Investigating the effect of helix angle and pressure angle on bending stress in helical gear under dynamic state

Abstract

Purpose The aim of this paper is to study the effect of pressure angle and helix angle on bending stress at the root of helical gear tooth under dynamic state. Gear design is a highly complex process. The consistent demand to build low-cost, quieter and efficient machinery has resulted in a gradual change in gear design. Gear parameters such as pressure angle, helix angle, etc. affect the load-carrying capacity of gear teeth. Adequate load-carrying capacity of a gear is a prime requirement. The failure at the critical section because of bending stress is an unavoidable phenomenon. Besides this fact, the extent of these failures can be reduced by a proper gear design. The stresses produced under dynamic loading conditions in machine member differ considerably from those produced under static loading. Design/methodology/approach The present work is intended to study the effect of pressure angle and helix angle on the bending stress at the root of helical gear tooth under dynamic state. The photostress method has been used as experimental methods. Theoretical analysis was carried out by velocity factor method and Spott’s equation. LS DYNA has been used for finite element (FE) analysis. Findings The results show that experimental method gives a bending stress value that is closer to the true value, and bending stress varies with pressure angle and helix angle. The photostress technique gives clear knowledge of stress pattern at root of tooth. Originality/value The outcomes of this work help the designer use optimum weight-to-torque ratio of gear; this is ultimately going to reduce the total bulk of the gear box.

Whole Field Analysis of Asymmetric Helical Gear Using Photo Stress Method and FEA Method

“…The surface of gear to be coated is flat. So considering above points PS-1 pre-manufactured sheet with thickness 3.05 mm (12) has been selected as photoelastic coating for analysis.…”

High-Speed Helical Gear Design Parameters Effect on the Dynamic Stress

“…Results show that the experimental method provides bending stress values closer to the actual value, and bending stress varies with Pressure angle and Helix angle. The research paper discussed gear angles and pressure angles under the influence of non-fixed variables, which is the focus of the presented work, but did not take into account transmission error [7]. Ductile stress and compressive stress could be reduced by 10% with an increase in the helix angle.…”

Spirit Kerja Karyawan Masa Pandemi Covid 19

“…Ini karena bagaimana persepsi beban kerja terkait erat dengan pekerjaan, apakah penilaian beban kerja individu dari serangkaian persyaratan untuk tugas atau kegiatan yang memerlukan aktivitas mental dan fisik untuk diselesaikan dalam periode waktu tertentu secara efektif mempengaruhi pekerjaannya secara positif atau negatif. Patil et al, (2018), menjelaskan indikator beban kerja berikut: Waktu kerja, waktu kerja yang diberikan kepada karyawan tidak boleh berlebihan, waktu kerja yang berlebihan akan berdampak buruk bagi kesehatan karyawan. Jumlah pekerjaan, jumlah pekerjaan yang dibebankan harus sesuai dengan kemampuan karyawan agar karyawan tidak mengalami.…”