Investigating Pitting Corrosion of Stainless Steel and Aluminium Using Scanning Vibrating Electrode Techniques and Electrochemical Noise Measurement

Abstract

Abstract:In this study, the susceptibility of aluminium (Al) and steel SS304 to pitting corrosion in FeCl 3 and NaCl solutions with varying pH values were investigated using electrochemical noise (ECN) measurement and Scanning Vibrating Electrode Technique (SVET). Preliminary surface drop test of SS304 in FeCl 3 solution and total immersion test of Al in NaCl solution indicated higher pitting of samples at scratches simulated by scribe. Total immersion test on both SS304 and Al indicated that protecting a sample with epoxy-resin mold does not completely eliminate crevice attack. ECN tests results showed that Al suffered severe time-variant corrosion in FeCl 3 solution unlike SS304. The results of SVET tests conducted after 24h immersion indicated that the early pits captured on Al samples were more intense than the later ones. Higher corrosion rates were obtained for samples in NaCl solution of pH 2.89 compared to pH 7.21, indicating that pitting increased with acidity. SVET maps obtained corroborated Scanning Electron Microscopy (SEM) images of the sampled surfaces. However, though SVET was unable to capture pitting of SS304 in the solutions, SEM image revealed pitting activity on the sample in FeCl 3 solution.

Study into the influence of concentration of ions of chlorine and temperature of circulating water on the corrosion stability of carbon steel and cast iron

“…Corrosion process has been studied in acidic solutions (pH=2), and circulating water have had a neutral or slightly alkaline pH value. The same applies to data from study [9], where a solution of FeCl 3 , which is a strong oxidant and is absent in circulating water, has been used as a corrosive medium.…”

“…Scientific data on the corrosive aggressiveness of chloride ions in water solutions with respect to ferrous metals are very numerous [1][2][3][4][5][6][7][8][9][10]. Most of the research in this direction has been carried out for alloy steels.…”