Interpretation of Fire Safety Distances of a Minivan Passenger Car by Burning Behaviors Analysis

Hu, Yue; Zhou, Xiaodong; Cao, Junda; Zhang, Liang; Wu, Gang; Yang, Lizhong

doi:10.1007/s10694-019-00938-1

Cited by 6 publications

(1 citation statement)

References 23 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…To ensure access to airflows, the windows on the ground floor of the facility were open. Work [10] reports the results that have made it possible to determine thermal radiation in spa-It was also established how these values are affected by engine configuration and driving conditions. It was found that the effective operation of both heat and smoke FDs is significantly dependent on their location and the movement of airflows in the engine compartment.…”

Section: Literature Review and Problem Statementmentioning

confidence: 99%

Operational algorithm for a heat detector used in motor vehicles

Kushnir¹,

Kopchak²,

Gavryliuk³

2021

EEJET

View full text Add to dashboard Cite

In most cases, fixed temperature heat detectors are used to detect fire in vehicles. The response parameter of such detectors is constant. The time of fire detection by a fire detector, as well as the probability of its false operation, are affected by heat flux from an internal combustion engine. This paper reports the development and investigation of an operational algorithm of the fixed-dynamic heat detectors with variable response parameters. Depending on the temperature influence exerted by engine operation modes, a given algorithm automatically changes a value of the minimal static response temperature of a detector, as well as value of the rate of rise in the temperature of its response. The experimental results showed that in the initial period of engine operation, the temperature change rate in the engine compartment fluctuates and is the largest. It can exceed 290 °С/min. However, regardless of the type of vehicle and the type of engine, when the temperature reaches technological, the temperature change rate would vary within small limits, approximately 30÷50 °С/min. The study results from the Simulink software package (USA) in the MATLAB programming environment (USA) confirm the effectiveness of the programmed operational algorithm of a thermal fire detector. The developed algorithm of a fire detector's operation makes it possible to detect the fire at an early stage and reduce the cases of the device's false response. The fire detector responded to both the maximal and dynamic components. As regards the maximal component, the proposed detector is triggered about 2.3 times faster than the classic maximal thermal fire detector. Detection of fire at an early stage makes it possible to quickly use the fire extinguishing system

show abstract

Section: Literature Review and Problem Statementmentioning

confidence: 99%