Integration of an EUV metal layer: a 20/14nm demo

Higgins, Craig; Verduijn, Erik; Hu, Xiang; Wang, Liang; Singh, Mandeep; Wandell, Jerome; Mehta, Sohan Singh; Fakhoury, Jean R.; Zaleski, M.; Zou, Yi; Koh, Hui Peng; Mangat, Pawitter J. S.

doi:10.1117/12.2048285

Cited by 2 publications

(1 citation statement)

References 8 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…There is inevitable demand for alternative patterning strategies which involve augmentation of 193i lithography with LELE (Litho-Etch-Litho-Etch), SADP (Self Aligned Double Patterning) and SAQP (Self Aligned Quadruple Patterning). [2][3][4][5] However, multiple patterning schemes bring in additional challenges in the form of Edge Placement Error, Higher Costs due Line Edge /Width Roughness / LCDU Line Collapse / Scummed or…”

Section: Introductionmentioning

confidence: 99%

Trench and hole patterning with EUV resists using dual frequency capacitively coupled plasma (CCP)

et al. 2015

View full text Add to dashboard Cite

Patterning at 10 nm and sub-10 nm technology nodes is one of the key challenges for the semiconductor industry. Several patterning techniques are under investigation to enable the aggressive pitch requirements demanded by the logic technologies. EUV based patterning is being considered as a serious candidate for the sub-10nm nodes. As has been widely published, a new technology like EUV has its share of challenges. One of the main concerns with EUV resists is that it tends to have a lower etch selectivity and worse LER/LWR than traditional 193nm resists. Consequently the characteristics of the dry etching process play an increasingly important role in defining the outcome of the patterning process.In this paper, we will demonstrate the role of the dual-frequency Capacitively Coupled Plasma (CCP) in the EUV patterning process with regards to improving LER/LWR, resist selectivity and CD tunability for holes and line patterns. One of the key knobs utilized here to improve LER and LWR, involves superimposing a negative DC voltage in RF plasma at one of the electrodes. The emission of ballistic electrons, in concert with the plasma chemistry, has shown to improve LER and LWR. Results from this study along with traditional plasma curing methods will be presented. In addition to this challenge, it is important to understand the parameters needed to influence CD tunability and improve resist selectivity. Data will be presented from a systematic study that shows the role of various plasma etch parameters that influence the key patterning metrics of CD, resist selectivity and LER/LWR. This work was performed by the Research Alliance Teams at various IBM Research and Development Facilities.

show abstract

Section: Introductionmentioning

confidence: 99%