Integrated analysis of in situ stress for tunneling underneath a municipal solid waste landfill

Zhao, Yong; Feng, Shi-Jin

doi:10.1007/s10064-023-03447-2

Cited by 3 publications

(1 citation statement)

References 44 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…They obtained the elastic modulus, Poisson’s ratio, cohesion, and internal friction angle of a landslide. Zhao and Feng [ 26 ] employed particle swarm optimization and multilinear regression to conduct an inversion analysis of the direction and magnitude of in situ stress along the tunnel. This analysis was based on geological conditions and measured stress.…”

Section: Introductionmentioning

confidence: 99%

Mechanical Behavior Monitoring and Load Inversion Analysis of Large-Diameter Underwater Shield Tunnel during Construction

Ma,

Ye,

Liu

et al. 2024

Sensors

View full text Add to dashboard Cite

The construction of large-diameter shield tunnels underwater involves complex variations in water and earth load outside the tunnel segment, as well as intricate mechanical responses. This study analyzes the variation laws of external loads, axial forces, and bending moments acting on the segment ring during the shield assembly and removal from the shield tail. It accomplishes this through the establishment of an on-site monitoring system based on the Internet of Things (IoT) and proposes a Bayesian-genetic algorithm model to estimate the water and earth pressure. The fluctuation section exhibits a peak load twice as high as that in the stable section. These variations are influenced by Jack thrust, shield shell force, and grouting pressure. The peak load observed in the fluctuation section is twice as high as the load observed in the stable section. During the shield tail removal process, the internal forces undergo significant fluctuations due to changes in both load and boundary conditions, and the peak value of the axial force during the fluctuation section is eight times higher than that during the stable section, while the peak value of the bending moment during the fluctuation section is five times higher than that during the stable section. The earth and water pressure calculated using the inversion analysis method, which relies on the measured internal forces, closely matches the actual measured values. The results demonstrate that the accuracy of the water and earth pressure obtained through inversion analysis is twice as high as that obtained using the full coverage pressure method. These results can serve as a valuable reference for similar projects.

show abstract

Section: Introductionmentioning

confidence: 99%