Influence of Various Stator Parameters on the Open-Water Performance of Pump-Jet Propulsion

Abstract

In order to improve the hydrodynamic performance of pump-jet propulsion (PJP) when matching stator with the rotor, the RANS method with SST k-ω turbulence model is employed to study the influence of six kinds of stator parameters, which are classified into three groups, i.e., stator solidity, stator angles and rotor–stator spacing (S). Results show that the stator solidity involves the blade number (Ns) and chord length (L), has an obvious acceleration effect at and after stator, and produces a higher thrust and torque with a slight efficiency change. Further comparing Ns and L results, we find greater distinctions between the two cases when stator solidity is greatly adjusted. Three stator angles, i.e., stagger angle (α), lean angle (γ), and sweep angle (β), are studied. The α has the biggest effect on the thrust, torque, and efficiency; meanwhile, it shifts the advance number that corresponds to maximum efficiency. The effect of γ is similar to α, but its influence is far less than α. However, there is little difference between various β cases except for off-design conditions, where the efficiency drops dramatically as β increases. The S has a slight effect on PJP performance. Even though S decreases 34% relative to the original PJP, the rotor thrust and torque increase by less than 1%. In addition, we compare torque balance locations under various parameters, and each component force is analyzed in detail to explain the reason for performance variation. The present work is conducive to future optimization in PJP design.

Study on the pulsation and fluid-structure coupling characteristics of rotating parts of vane type mixed-flow pump

“…Scholars have employed various techniques such as unsteady numerical simulation, flow-solid coupling, and fluid-structure coupling to investigate different aspects of these pumps. Ning Chao [2], Lu Jin [3], Liang Kaihong [4] and Li Tongqiao [5] utilized numerical simulation techniques to study the hydraulic characteristics of the flow field inside the pump internal impeller. Additionally, Shi Weidong [6], Yang Fan [7] and Li Yibin [8] carried out unsteady numerical simulations to obtain the pulsation characteristics of the internal impeller of MFP.…”