2019
DOI: 10.1038/s41598-018-36935-7
|View full text |Cite
|
Sign up to set email alerts
|

Influence of surface ocean density on planktonic foraminifera calcification

Abstract: This study provides evidence that ambient seawater density influences calcification and may account for the observed planktonic foraminifera shell mass increase during glacial times. Volumes of weighed fossil Globigerina bulloides shells were accurately determined using X-ray Computer Tomography and were combined with water density reconstructions from Mg/Ca and δ18O measurements to estimate the buoyancy force exerted on each shell. After assessment of dissolution effects, the resulting relationship between sh… Show more

Help me understand this report

Search citation statements

Order By: Relevance

Paper Sections

Select...
2
1
1
1

Citation Types

7
24
0
1

Year Published

2019
2019
2023
2023

Publication Types

Select...
8

Relationship

1
7

Authors

Journals

citations
Cited by 32 publications
(32 citation statements)
references
References 69 publications
7
24
0
1
Order By: Relevance
“…However, the absolute G. bulloides shell mass values for specimens 300-350 µm in size reported here for a tropical Atlantic site are low compared with the North Atlantic records [48,50]. This is consistent with the influence of seawater densities on shell weights [7], as the lowest sea surface density values are found in the tropical waters, where salinity is lowest due to excess rainfall associated with the intertropical convergence zone, and increases toward the poles [51]. At higher latitudes, G. bulloides shell weight changes by around one-third over glacial-interglacial cycles [3,50,52], and a similar variability in test weight is seen through the Pliocene glacial-interglacial cycles at a similar location [48].…”
Section: Discussionsupporting
confidence: 86%
See 2 more Smart Citations
“…However, the absolute G. bulloides shell mass values for specimens 300-350 µm in size reported here for a tropical Atlantic site are low compared with the North Atlantic records [48,50]. This is consistent with the influence of seawater densities on shell weights [7], as the lowest sea surface density values are found in the tropical waters, where salinity is lowest due to excess rainfall associated with the intertropical convergence zone, and increases toward the poles [51]. At higher latitudes, G. bulloides shell weight changes by around one-third over glacial-interglacial cycles [3,50,52], and a similar variability in test weight is seen through the Pliocene glacial-interglacial cycles at a similar location [48].…”
Section: Discussionsupporting
confidence: 86%
“…The same applies with the reconstructed densities of the water column that reveal lighter waters during the glacial and denser waters after MIS 6.1. Following the previous study [7], shell weights were plotted against the reconstructed seawater density values and a significant (R 2 = 0.43, p < 0.05, n = 12) relationship between these parameters was verified (Figure 5d), which becomes even more significant (R 2 = 0.74, p < 0.01, n = 12) if the (upper right) two heaviest (most contaminated by clay infillings) samples are omitted. It is evident that these two samples of excessive shell weights deviate from the resulting regression line.…”
Section: Resultsmentioning
confidence: 99%
See 1 more Smart Citation
“…Based on calibration between SNW in core-top sediments and bottom-water Δ[CO 3 2− ] in the equatorial Pacific, size-normalized test weights have served as a proxy for deep seawater [CO 3 2− ] (e.g., Broecker & Clark, 2001;Qin et al, 2017). In contrast, the test area density (μg μm −2 ) of foraminifera, which is the ratio of the weight of a test to its projected area, is a more rigorous size-standardized proxy than SNW, and it is also employed as a proxy of calcification intensity controlled by sea surface conditions (e.g., Moy et al, 2009;Weinkauf et al, 2013;Zarkogiannis et al, 2019). Sea surface conditions where foraminifera calcify can influence the thickness of foraminiferal test walls (Marshall et al, 2013) and bulk density (Iwasaki et al, 2019), which implies that the initial weights of foraminiferal tests differ depending on growth conditions as suggested in Barker and Elderfield (2002); thus, the test weight proxies SNW and test area density may be affected by not only dissolution at the deep seafloor but also calcification at the sea surface.…”
Section: Introductionmentioning
confidence: 99%
“…Densitas perairan (kombinasi dengan suhu dan salinitas) berkontribusi terhadap sebaran (dispersal) dari larva planktonis biota laut (Marsh et al, 2001). Lebih lanjut, densitas perairan dapat mempengaruhi proses kalsifikasi cangkang plankton foraminifera (Zarkogiannis et al, 2019).…”
Section: Analisis Pca Parameter Fisika Oseanografis Perairanunclassified