Influence of Pressure Oscillations in Common Rail Injector on Fuel Injection Rate

Abstract

Fuel injection causes considerable oscillations of fuel pressure at the injector inlet. One of the reasons is hydraulic impact when the needle valve closes. For multiple injections, the previous injections affect the following. As both the fuel pressure in rail pac and the injection rate grow, the oscillations increase. The pressure oscillation range at the common rail injector inlet at pac=1500 bar is up to 350 bar, and at the rail pressure pac=500 bar, the amplitude decreases to 80 bar. Physical properties of the fuel are also important. As the viscosity of the fuel increases, its hydraulic friction grows which results in a rapid damping of pressure oscillations. The data for an injector operating on sunflower oil is presented. As compared with diesel fuel, the oscillations range decreases from 400 to 250 bar at the same operating mode. The influence of the interval between the impulses of a double injection on the injection rate of the second fuel portion was investigated. Superposition of two waves during multiple injections may result in amplification and damping of the oscillations. Simulation was performed to estimate the influence of fuel type and time interval Δτ between control impulses of a double injection on the injection quantity of the second portion at pressures of 2000-3000 bar. When the rail pressure pac grows, the oscillations and their impact on the injection process increase. For diesel fuel at pressure of pac=2000 bar, the variation in injection rates of the second portion is 2.36-4.62 mg, and at pac=3000 bar – 1.58-6.63 mg.

Forecasting of a boosted locomotive gas diesel engine parameters with one- and two-stage charging systems

“…Highly boosted diesel and gas diesel engines require advanced diesel fuel supply systems. As the air density in the cylinder increases, the fuel supply systems should ensure higher injection pressure, injection rate front shape control to decrease NOx emissions and one should take into account fuel pressure oscillations in the high pressure line having a considerable impact on the fuel injection process in case of a high fuel injection pressure and multistage injection (Shatrov et al, 2020).…”