Influence of Microgroove Structure on Cutting Performance and Chip Morphology during the Turning of Superalloy Inconel 718

Zou, Zhongfei; Lin, He; Jiang, Hongwan; Yuan, Sen; Ren, Ziyan

doi:10.3390/ma14154142

Cited by 8 publications

(2 citation statements)

References 37 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…The tool life of the micro-grooved cutting tool was 23.08% longer than that of a similar untreated tool. It also improves the process of chip destruction, which has a positive effect on the stability of the tool [27].…”

Section: Carbidementioning

confidence: 99%

Pareto Analysis of Machining Factors Significance When Turning of Nickel-Based Superalloy Inconel 718

Yevdokymov

Kolesnyk

Peterka

et al. 2023

Metals

View full text Add to dashboard Cite

Nickel superalloys occupy a reasonably broad niche in the industry. One of this group’s most common and well-known alloys is Inconel 718. Parts from Inconel 718 are used in aerospace, energy, automotive, and some other vital industries, which creates a demand for research and improvement of the machining conditions of this alloy. This article is devoted to the systematization and generalization of the accumulated experience of machining of Inconel 718 at turning operation. The research methodology is based on the Pareto distribution. In the study, more than 50 articles devoted to turning Inconel 718 were analyzed. The tool materials, methods, and types of coating used in turning Inconel 718 were analyzed. Finite element method modeling of processing processes has been considered. The trends in the selection of cutting parameters and the geometry of the cutting tool and finite element method modeling of processing processes have been considered. Lacunae for promising future research were formulated.

show abstract

Section: Carbidementioning

confidence: 99%

Pareto Analysis of Machining Factors Significance When Turning of Nickel-Based Superalloy Inconel 718

Yevdokymov

Kolesnyk

Peterka

et al. 2023

Metals

View full text Add to dashboard Cite

show abstract

“…Fatima et al [16] while optimising the machining process for structured cutting tool observed that structured cutting tool develop less flank wear than traditional cutting tool. Zou et al [17] studied the performance of structured tool in machining of inconel 718 alloy and identified that tool life was increased by 23% in comparison to traditional tool.…”

Section: Introductionmentioning

confidence: 99%

Effect of rake face surface of cutting tool on tool crater wear

Fatima,

Wasif,

Ahmed

et al. 2023

Manufacturing Rev.

View full text Add to dashboard Cite

Tool wear is complex to predict due to the intricate environment of a machining process. However, there are a confrontational effect of tool wear on the machining process in terms of deprived surface finish, reduced dimensional accuracy and increased power consumption. In this study an attempt is made to examine the effect of rake face surface of the cutting tool on tool crater wear. For this, three different types; uncoated, coated and structured rake face cutting tools were used and cutting test were performed of plain carbon steel (AISI/SAE 4140). The cutting speed of 283 m/min, feed rate of 0.1 mm/min and depth of cut of 0.1 were used. Results show, structured rake face of the cutting tool benefitted most in supressing the tool crater wear. Energy-Dispersive X-Ray analysis (EDXA) analysis confirms reduction in iron transfer on tool rake face in case of coated and structured cutting tool. Micro − hardness test was also performed and the values in case of coated and structured cutting tool was found to be suffice. This study can be a benefit for cutting difficult to cut material where crater wear formation is unavoidable.

show abstract