Influence of graphite nodules on the particles erosion of spheroidal graphite cast irons

Chang, L. C.; Hsui, I. C.; Chen, Lihui; Lui, S. T.

doi:10.1016/j.wear.2004.07.011

Cited by 8 publications

(4 citation statements)

References 14 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…There is one "bad" data point in the figures, and the datum was obtained from a microstructure of untempered martensite rather than bainite. The deviated point is not unexpected, since cracking is the dominated mechanism for erosion in the martensitic ductile iron, while extrusion of lips is main mechanism for ADIs [13].…”

Section: Further Discussionmentioning

confidence: 89%

“…The content, nodule count, and nodule size of graphite were determined to be 14.53 vol.%, 88 no./mm 2 , and 45.76 m, respectively. The details of the determinations were described elsewhere [13].…”

Section: Experimental Materialsmentioning

confidence: 99%

“…One of the major applications of austempered ductile irons is subjected to serious wear damage. Erosive wear, among other kinds of wear processes, of austempered ductile irons has attracted much attention [4][5][6][7][8][9][10][11][12][13].…”

Section: Introductionmentioning

confidence: 99%

See 2 more Smart Citations

Effects of heat treatment on the erosion behavior of austempered ductile irons

Chang¹,

Hsui²,

Chen³

et al. 2006

Wear

Self Cite

View full text Add to dashboard Cite

Section: Further Discussionmentioning

confidence: 89%

Section: Experimental Materialsmentioning

confidence: 99%

See 1 more Smart Citation

Effects of heat treatment on the erosion behavior of austempered ductile irons

Chang¹,

Hsui²,

Chen³

et al. 2006

Wear

Self Cite

View full text Add to dashboard Cite

“…[13][14][15] However, few reports discussed the particle erosion for MSS. 16) In order to understand the erosion wear mechanism and to build a base for slurry erosion test further, the particle erosion test was carried out first in this study.…”

Section: Introductionmentioning

confidence: 99%

Particle Erosion of SUS403 Tempered Martensitic Stainless Steel

Wen

2006

ISIJ Int.

View full text Add to dashboard Cite

The particle erosion behavior of SUS403 martensitic stainless steel tempered with five different temperatures range from 200 to 600°C were studied as a function of impact angle and hardness. The results indicate that the dominated mechanisms for material removal are cutting and extrusion at low and high impact angles, respectively. A transition of mechanism mixed by cutting and extrusion occurs at medium impact angle. Grain boundary cracking is often found for all impact angles that seem to be one of the major erosion mechanisms for two-phase materials mixed with martensite and ferrite. The erosion rate of all the experimental materials increases first, and then decreases with increase in impact angle. Thus, the maximum erosion rate occurs at the angle between 30°and 45°. At 15°and 30°of impingement, the erosion rate is virtually independent of hardness. While impact angles exceed than 30°, erosion rate increases with increasing hardness.

show abstract