Influence of Cross-Link Structure on Impact Strength of ABS.

Ikawa, Kiyoshi; Sakano, Hajime; Tamai, Seiji; Takahashi, Kazunori; Kojima, Hiroshi

doi:10.1295/koron.54.148

Cited by 2 publications

(2 citation statements)

References 0 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…Over the past decades, ABS and the series of related composites have been studied extensively [1][2][3][4][5][6][7][8][9] , they are a widely used commodity. However, their relative products do not continue to meet people's needs with improvement of living standards.…”

Section: Introductionmentioning

confidence: 99%

Preparation and Properties of Fragrant Acrylonitrile-Butadiene-Styrene Composites

Liu

Yang

Jiang

et al. 2009

Polymer-Plastics Technology and Engineering

View full text Add to dashboard Cite

The aim of the present work is to upgrade the functionality and applicability of acrylonitrile-butadiene-styrene (ABS) composites by means of a blending technique. Fragrant ABS composites were prepared by adding a fragrance into the ABS matrix. It was found that the volatility of the essence was greatly affected by the nature of the essence, the environmental temperature and the polymer matrix. In addition, the impact strength and yield strength decreased gradually with increasing fragrance content, but the processing properties were improved rapidly and rate of elongation at the break increased rapidly. The fragrance of the fragrant ABS composites could be maintained for a long time at room temperature.

show abstract

Section: Introductionmentioning

confidence: 99%

Preparation and Properties of Fragrant Acrylonitrile-Butadiene-Styrene Composites

Liu

Yang

Jiang

et al. 2009

Polymer-Plastics Technology and Engineering

View full text Add to dashboard Cite

show abstract

“…Figure 2 shows the stress-strain curves of these ABS samples during stretching at 5mm/min. ABS-A and C, which contain the highly grafted rubber particles, show the higher elastic moluli than ABS-B and D. Igawa et al [7] found that the crosslinking reaction was induced in the poly (butadiene) particle by radicals due to an initiator for the graft reaction. Besides, the rubber particles contain some SAN occlusions at high graft ratio.…”

Section: Introductionmentioning

confidence: 99%

Effect of Rubber Particle Size and Graft Ratio on the Morphology and Tensile Properties of ABS Resins

Yamane

Maekawa

Sakano

2000

Journal of the Society of Materials Science, Japan

Self Cite

View full text Add to dashboard Cite

Tensile properties and the phase morphologies of ABS resins with various rubber particle sizes and graft ratios of SAN are examined. Large rubber particles disperse well in ABS resins irrespective of the graft ratio. On the other hand, the graft ratio affects the dispersion state of the small rubber particle, particles with high graft ratio disperse well and those with low graft ratio tend to coalesce into large aggregates. These differences of the morphology strongly alter the deformation mechanism, such as craze formation and cavitation in the rubber particles. The effects of mixing of ABS resins with various graft ratio and particle size on the mechanical properties and phase morphology are also discussed.

show abstract

Influence of Cross-Link Structure on Impact Strength of ABS.

Cited by 2 publications

References 0 publications

Preparation and Properties of Fragrant Acrylonitrile-Butadiene-Styrene Composites

Preparation and Properties of Fragrant Acrylonitrile-Butadiene-Styrene Composites

Effect of Rubber Particle Size and Graft Ratio on the Morphology and Tensile Properties of ABS Resins

Contact Info

Product

Resources

About