Influence of Alternating Short-Cycle Bending on the Mechanical Properties of Copper, α-Titanium and the Mild Steel DC01

Barienti, Khemais; Wolff, Daniel; Herbst, Sebastian; Nürnberger, Florian; Maier, Hans Jürgen

doi:10.1007/s11665-019-04458-5

Cited by 1 publication

(1 citation statement)

References 10 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…A clear explanation for the dependence of the springback behavior on low-cycle loading with very small amplitudes is not yet established since a variety of parameters such as the microstructure, heat treatment, pre-strain, texture changes or residual stress changes play a role ( Ref 2,6,[8][9][10]. Hence, the effect of alternating low-cycle uniaxial loading with very small deformation near the elastic-plastic transition was investigated in the present study.…”

Section: Introductionmentioning

confidence: 99%

Influence of Pre-strain on Very-Low-Cycle Stress–Strain Response and Springback Behavior

Barienti

Klein

Wackenrohr

et al. 2021

J. of Materi Eng and Perform

Self Cite

View full text Add to dashboard Cite

The influence of pre-strain on the very-low-cycle loading behavior as occurring, for example during roller leveling of sheet metals, is not yet fully understood. A key factor in this context is the stiffness of the material and its changes upon processing. To study the general mechanical property changes during low-cycle loading with small amplitudes for a wide variety of metals, sheet samples of mild steel DC01, pure copper CU-DHP and α-titanium are subjected to low-cycle tension–compression tests. The general influences of pre-strain and the applied strain amplitude are investigated regarding material hardening and changes in the elastic properties. It is shown that all tested materials feature changes in the Bauschinger behavior during cycling. The apparent elastic modulus of the materials decreases with increasing accumulated plastic strain, and the evolution depends on the strain amplitude and the pre-strain. For all three materials, changes in technical springback are present and depend on the loading history.

show abstract

Section: Introductionmentioning

confidence: 99%