Influence of abrasive water jet and conventional drilling on the fatigue performance of hybrid carbon/flax laminates

Abstract

Most of the research on hybrid natural fiber composites has been focused on non-structural applications. The aim of this research is to improve the understanding of how to use hybrid natural fiber composites for structural applications, such as in the aerospace and automotive industries. The joining of subassemblies with rivets, bolts, or screws is a prominent feature in these industries, which implies that the presence of holes in the structural members is unavoidable. The study of the effect of holes on the mechanical behavior of these members is therefore imperative, especially given that holes are stress risers. An important factor in the design of open-hole hybrid flax composites is their fatigue behavior under cyclic loading because it accounts for most failures in composite structures. The investigation of this behavior is reported in this study where three types of 16-ply symmetric hybrid composites that were manufactured using woven carbon (C) and unidirectional flax (F), namely, unidirectional (CF[0]), cross-ply (CF[0/90]) and angle-ply (CF[[Formula: see text] 45]) are employed. A circular hole was made in the center of each specimen using either an abrasive water jet or conventional drilling methods. The observed machining-induced critical defect was delamination, which manifested in three forms: peel-up, push-out, and secondary. Stepwise fatigue tests were conducted to determine the damage evolution and high-cycle fatigue strength of each layup. The damage evolution of the material was assessed via stiffness damage, thermographic methods, and dissipated energy per cycle. It was observed that CF[0] layups are unaffected by the machining process and they have an identical high-cycle fatigue strength. For the CF[0/90] and CF[[Formula: see text] 45] layups, conventional drilling specimens have a higher high-cycle fatigue strength than their abrasive water jet counterparts.

Drilling Parameters and Post-Drilling Residual Tensile Properties of Natural-Fiber-Reinforced Composites: A Review

“…In recent years, more specific data have started to be obtained on the fatigue performance of drilled natural fiber composites. A study on carbon/flax-hybrid-reinforced laminates increased the level of concern about the application of non-traditional drilling procedures such as waterjet cutting, which offered a shorter fatigue life, particularly for cross-ply laminates (0/90 and ±45) compared to conventional ones [104]. When dealing with the long-term behavior of natural fiber composites, other issues become important, such as the effect of hygrothermal aging on post-drilling fatigue; for short birch fiber/high density polyethylene (HDPE) composites, the influence of the treatment on the composites' fatigue performance was demonstrated to be minimal, which was a promising result with respect to the possible fabrication of spur gear using this composite [105].…”