In-medium effect with muon-neutrino and anti-muon-neutrino quasi-elastic scattering from¹²C nucleons

Abstract

We investigated the in-medium effect by density-dependent axial and weak-vector form factors on muon-neutrino ( ) and anti-muon-neutrino scattering in the quasi-elastic (QE) region from nucleons (N*) bound in a nucleus or immersed in a nuclear medium via neutral current (NC) and charged current (CC). For the density-dependent form factors, we exploited a quark–meson-coupling (QMC) model. We found that the scattering cross sections via NC in the QE region usually decrease with an increased medium density, while those using CC were increased. However, their rate of change was sensitive to the four-momentum transfer given to a bound nucleon through scattering. We compared these results obtained by the elementary process corrected by the in-medium effect to the BNL and MiniBooNE data, which measured scattering cross sections per nucleon through – 12C scattering in 12C composite targets. The incident energy range was 550 3000 MeV. We increased the energy up to 100 GeV to compare our results to the NOMAD experimental data. In order to study the density effects on a nucleon embedded in 12C, we exploited the QMC form factors evaluated at , where the normal density . The strangeness contributions in NC scattering are also incorporated into the form factors for comparison with experimental data. Our numerical results show that most of the experimental data can be explained in a satisfactory manner by the density-dependent elementary process, but there are some remaining deviations resulting from the nuclear structure, particularly in the low and high momentum-transfer regions.

Neutrino-induced Reactions and Neutrino Scattering with Nuclear Targets

“…Then we exploit following cross section for ν(ν) scattering off the nucleon inside target nucleus via NC (CC) by taking density-dependent form factors for the in-medium effects [22,23] [24]. Results for a free neutron (proton) and neutron (proton) in a carbon target are denoted as solid (black) and dotted (red) curves, respectively.…”