Improving the binding efficiency of quartz crystal microbalance biosensors by applying the electrothermal effect

Abstract

A quartz crystal microbalance (QCM) serving as a biosensor to detect the target biomolecules (analytes) often suffers from the time consuming process, especially in the case of diffusion-limited reaction. In this experimental work, we modify the reaction chamber of a conventional QCM by integrating into the multimicroelectrodes to produce electrothermal vortex flow which can efficiently drive the analytes moving toward the sensor surface, where the analytes were captured by the immobilized ligands. The microelectrodes are placed on the top surface of the chamber opposite to the sensor, which is located on the bottom of the chamber. Besides, the height of reaction chamber is reduced to assure that the suspended analytes in the fluid can be effectively drived to the sensor surface by induced electrothermal vortex flow, and also the sample costs are saved. A series of frequency shift measurements associated with the adding mass due to the specific binding of the analytes in the fluid flow and the immobilized ligands on the QCM sensor surface are performed with or without applying electrothermal effect (ETE). The experimental results show that electrothermal vortex flow does effectively accelerate the specific binding and make the frequency shift measurement more sensible. In addition, the images of the binding surfaces of the sensors with or without applying electrothermal effect are taken through the scanning electron microscopy. By comparing the images, it also clearly indicates that ETE does raise the specific binding of the analytes and ligands and efficiently improves the performance of the QCM sensor. V C 2014 AIP Publishing LLC. [http://dx

Low-Fouling Characteristics of Ultrathin Zwitterionic Cysteine SAMs

“…This section discusses QCM calibration and explains all artifacts produced as a result of the experimental procedure. When one face of the quartz crystal resonator is in contact with a liquid, the change in frequency (Δ F ) can be expressed by eq , − where ρ q is the density of quartz crystal (2.648 g·cm –3 ), μ q is the shear modulus of quartz (2.947 × 10 11 g·cm –1 ·s –2 ), f 0 is the frequency of the loaded crystal, A is the piezoelectrically active crystal area (given by the manufacturer as 0.1 cm 2 ), Δ m is the change in mass, η L is the viscosity of the liquid, and ρ L is the density of the liquid. From eq , the resonant frequency can be disturbed by either a change in surface mass (caused by film deposition or decay), a change in viscosity of the liquid or a change in density of the liquid.…”

Enhancement of COVID-19 detection time by means of electrothermal force

“…The AC electrothermal effect (ACET) was implicated in different biological technologies (Salari and Thompson 2018;Gao and Li 2019;Selmi et al 2015Selmi et al , 2016aSelmi et al , b, 2017Sin et al 2010;Huang and Chang 2013). It is well known that the ACET effect is more efficient at high frequencies (above 100 kHz), and when having a solution with an electrical conductivity σ that exceeds the value of 0.002 S/m (Huang et al 2014). Under these conditions, both experimental and numerical studies on the heterogeneous binding assays biotin/streptavidin have been achieved by Feldman et al (2007).…”

AC Electroosmosis Effect on Microfluidic Heterogeneous Immunoassay Efficiency

“…The AC electrothermal effect (ACET) was massively involved in the last decade of research on different biological technologies [22][23][24][25][26][27][28][29]. The ACET effect is effective at high frequencies (larger than 100 kHz) in a solution having a large electrical conductivity σ (greater than 0.002 S/m) [30]. Feldman et al [21] performed experimental and numerical investigations.…”