Improving compressibility and thermal properties of Al–Al2O3 nanocomposites using Mg particles

Fabrication and evaluation of tribological properties of Al2O3 coated Ag reinforced copper matrix nanocomposite by mechanical alloying

“…The coefficient of friction of all the nanocomposites are smaller than the Cu matrix because of the presence of alumina coated by silver particles. During sliding action, alumina coated by silver particles are pulled out form Cu matrix and slide at the contact surface reducing coefficient of friction [60,61].…”

Fabrication and investigation on the properties of ilmenite (FeTiO3)-based Al composite by accumulative roll bonding

“…As a result, the metal–metal contacts and finally the bonding between the aluminum sheets could be created. 38–40…”

Microstructure and mechanical behavior of Al-xMg/5Al2O3nanostructured composites

“…Also the effect of high energy milling on morphology, microstructure and mechanical properties of the individual composite has been studied. Hence, the use of Al-Mg binary substrates has been considered in the production of Al substrate composites [12][13][14][15][16][17].…”

“…The equilibrium solubility of Mg in Al at room temperature has been reported lower [19] than one atomic percentage while, this value can be increase up to 45 atomic percentages for Al-50at%Mg alloy [20]. Further research in this area has proved the formation of intermetallic compounds with 20% Mg and above [12][13][14][15][16][17][18][19][20]. Therefore, the objective of this study is to investigate the effect of various compounds (0, 4, 8 and 12% Mg) which less has been investigated.…”