Improved permeability and core loss of amorphous FeSiB /Ni-Zn ferrite soft magnetic composites prepared in an external magnetic field

Chang, Jiasong; Zhan, Tongkang; Peng, Xiaoling; Li, Jing; Yang, Yanting; Xu, Jingcai; Hong, Bo; Jin, Dingfeng; Jin, Hongxiao; Wang, Xinqing; Ge, Hongliang

doi:10.1016/j.jallcom.2021.161335

Cited by 35 publications

(2 citation statements)

References 37 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…The magnetic properties of SMC composites can also be improved by using powders with amorphous microstructure [10,[12][13][14]. As a result of using nanocrystalline or amorphous materials, SMC composite can be obtained with lower core losses, including even in the absence of an oxide layer and in low-frequency fields (466.5 mV at 100 kHz and 50 mT and low coercivity (35 A/m).…”

Section: Simulation Of Magnetic Properties Of Composites Based On Mag...mentioning

confidence: 99%

3D Printing of Composite Material for Electromechanical Energy Harvesters

et al. 2022

View full text Add to dashboard Cite

In this paper, a novel, composite material is proposed based on ferromagnetic wires immersed in a polymer that is well suited for 3D printing. The magnetic properties of this material are examined using FEM and compared with the properties of a more traditional composite based on magnetic powder. For a 50% ferromagnetic volume in the material, the proposed composite has a 67% higher value of saturation magnetic flux density and 87% higher value of maximum permeability, compared with the powder-based material. The authors believe that the proposed material could be used in the manufacturing of small electromechanical devices such as energy harvesters, thus vastly widening the possible fields of application related to 3D printing techniques.

show abstract

Section: Simulation Of Magnetic Properties Of Composites Based On Mag...mentioning

confidence: 99%

3D Printing of Composite Material for Electromechanical Energy Harvesters

et al. 2022

View full text Add to dashboard Cite

show abstract

“…That is, for use in electric transport, a range of various engines is required, the energy costs of which will be consistent and optimized in relation to the function performed [2][3]. The adopted programs for the development of electric transport in Belarus and Uzbekistan [4,[6][7][8][9][10][11] and the action strategy for the further development of the Republic of Uzbekistan for 2021-2025 define the development and use of high-performance equipment, the creation and implementation of new technologies and production capacities, etc. [12][13][14][15][16].…”

Section: Introductionmentioning

confidence: 99%

Production of motor-wheels for prototypes of mini-electric vehicles based on new soft magnetic materials

Govor,

Demidenko,

Zhaludkevich

et al. 2023

E3S Web of Conf.

View full text Add to dashboard Cite

This article discusses the issue of production a motor-wheel for prototypes of mini-electric vehicles based on new soft magnetic materials. The structure and morphology of the surface obtained composite materials have studied. The density value calculated from the X-ray diffraction data is about 3% higher than the directly measured values, which are 7.7 g/cm3. Technologies and create new technical means and their effective use, the results of development and research of magnetic materials and complex technology for constructing electric motors based on them are disparate and do not allow the creation of new approaches for their mass implementation. Tests of the electromagnetic characteristics of magnetic circuits based on the materials obtained for constructing an electric drive were carried out using an express magnetometer.

show abstract