Impact of Immediate and Delayed Photo-activation of Self-adhesive Resin Cements on Bonding Efficacy and Water Uptake Under Simulated Pulpal Pressure

Abstract

SUMMARY This study investigated the effect of immediate versus delayed photo-activation on the bonding performance and water uptake of self-adhesive (SA) resin cements under simulated pulpal pressure (SPP). The occlusal dentin surface was exposed in 66 extracted third molars. Resin composite cylinders were cemented to dentin under SPP, with either RelyX Unicem 2 (RU) (3M Oral Care, St Paul, MN, USA) or Maxcem Elite (MC) (Kerr, Orange, CA, USA). Each cement group was equally divided into three groups (n=8 each) according to the time elapsed between placement and photo-activation: immediate activation (IM), 30-second delayed activation (D30), or 120-second delayed activation (D120). Shear bond strength (SBS) was measured, and the type of failure was determined using a stereomicroscope. Three additional samples from each experimental subgroup were used for confocal laser scanning microscopy (CLSM) analysis. A fluorescent dye solution was added to the pulpal fluid reservoir, then a CLSM was used to detect the dye distribution within the tooth-restoration interface. Two-way analysis of variance (ANOVA) and the Tukey post-hoc test were used to analyze the SBS results (α=0.05). D30 resulted in a significantly higher mean SBS in the two cement groups than IM and D120 (p<0.05). RU showed significantly higher SBS values than MC regardless of the time of light activation (p<0.05). RU showed less dye uptake confined to the cement-dentin interface compared to the MC groups, which showed dye uptake throughout the entire thickness of the cement layer and gap formation at the interface, especially in the D120 group. The 30-second photo-activation delay group significantly improved the bond strength of SA cements. Delaying the photo-activation to 120 seconds increased pulpal fluid uptake by SA cements and compromised the integrity of the bonded interfaces.