Identification of optimal operating strategy of direct air-cooling condenser for Rankine cycle based power plants

Li, Xiaoen; Wang, Ningling; Wang, Ligang; Yang, Yongping

doi:10.1016/j.apenergy.2017.10.081

Cited by 29 publications

(12 citation statements)

References 43 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…The cost-optimal design of a dry-cooling system for power plants was investigated in [161] with SQP and relevant decomposition methods, which showed that with well-structured optimization problem and solving strategy, the direct optimization of complex problems is not necessary to be time-consuming and difficult. Similar optimization problem for modern coal-fired power plants is solved in [162] considering more comprehensively the off-design performance of the whole plant calibrated with historical operating data, thus potentially yielding practical operating strategies to cope with different operating scenarios of power plants. The SQP algorithms are also employed in [158] to optimize the steam cycles considering its interaction with boiler cold-end, which took the steam-extraction pressures as independent variables to optimize the overall plant efficiency.…”

Section: Scope and Key Resultsmentioning

confidence: 99%

A Review of Evaluation, Optimization and Synthesis of Energy Systems: Methodology and Application to Thermal Power Plants

et al. 2018

Self Cite

View full text Add to dashboard Cite

To reach optimal/better conceptual designs of energy systems, key design variables should be optimized/adapted with system layouts, which may contribute significantly to system improvement. Layout improvement can be proposed by combining system analysis with engineers’ judgments; however, optimal flowsheet synthesis is not trivial and can be best addressed by mathematical programming. In addition, multiple objectives are always involved for decision makers. Therefore, this paper reviews progressively the methodologies of system evaluation, optimization, and synthesis for the conceptual design of energy systems, and highlights the applications to thermal power plants, which are still supposed to play a significant role in the near future. For system evaluation, both conventional and advanced exergy-based analysis methods, including (advanced) exergoeconomics are deeply discussed and compared methodologically with recent developments. The advanced analysis is highlighted for further revealing the source, avoidability, and interactions among exergy destruction or cost of different components. For optimization and layout synthesis, after a general description of typical optimization problems and the solving methods, the superstructure-based and -free concepts are introduced and intensively compared by emphasizing the automatic generation and identification of structural alternatives. The theoretical basis of the most commonly-used multi-objective techniques and recent developments are given to offer high-quality Pareto front for decision makers, with an emphasis on evolutionary algorithms. Finally, the selected analysis and synthesis methods for layout improvement are compared and future perspectives are concluded with the emphasis on considering additional constraints for real-world designs and retrofits, possible methodology development for evaluation and synthesis, and the importance of good modeling practice.

show abstract

Section: Scope and Key Resultsmentioning

confidence: 99%

A Review of Evaluation, Optimization and Synthesis of Energy Systems: Methodology and Application to Thermal Power Plants

et al. 2018

Self Cite

View full text Add to dashboard Cite

show abstract

“…Recently, Li et al (2018b) performed data-driven modelling of an air-cooled condenser in a 660 MW power plant. They investigated the optimal operating fan frequency to a maximum power gain.…”

Section: Full-scale Investigationsmentioning

confidence: 99%

“…It was seen that an increase in the fan frequency increases the heat transfer on the air side, despite a rise in power consumption. In addition, Li et al (2018b) claimed that the performance of the plant degrades with time and therefore the performance of a plant differs from the design specifications of the manufacturer. Hence, real operating data should be used to adjust off-design models.…”

Section: Full-scale Investigationsmentioning

confidence: 99%

“…The heat transfer coefficient algorithm based on film-wise condensation was the least accurate one. Li et al (2018b), whilst focusing on air-cooled condensers, reviewed the challenge of employing numerical simulation, highlighting that the analysis of the distribution of the temperature and fluid fields in multiple scales (from fin, to fan, to fan clusters, to fan island, etc.) may provide useful information on how to improve the condenser design itself.…”

Section: Full-scale Investigationsmentioning

confidence: 99%

See 1 more Smart Citation

Thermal Energy Processes in Direct Steam Generation Solar Systems: Boiling, Condensation and Energy Storage – A Review

et al. 2019

View full text Add to dashboard Cite

show abstract

“…The stream data related to all regenerative heats (RHs) have been listed in Table 1 for the turbine heat rate acceptance (THA) condition, under which the inlet conditions and back pressure of the turbine are nominal with the regenerative feedwater preheaters operating normally. More detailed descriptions of 1000 MW-level coal-fired power plants can be found elsewhere in our publications, e.g., [ 58 , 59 , 60 , 61 , 62 , 63 ], and will not be repeated here.…”

Section: Description Of Case Studiesmentioning

confidence: 99%

Comparative Evaluation of Integrated Waste Heat Utilization Systems for Coal-Fired Power Plants Based on In-Depth Boiler-Turbine Integration and Organic Rankine Cycle

Huang

Tan

et al. 2018

Entropy

Self Cite

View full text Add to dashboard Cite

To maximize the system-level heat integration, three retrofit concepts of waste heat recovery via organic Rankine cycle (ORC), in-depth boiler-turbine integration, and coupling of both are proposed, analyzed and comprehensively compared in terms of thermodynamic and economic performances. For thermodynamic analysis, exergy analysis is employed with grand composite curves illustrated to identify how the systems are fundamentally and quantitatively improved, and to highlight key processes for system improvement. For economic analysis, annual revenue and investment payback period are calculated based on the estimation of capital investment of each component to identify the economic feasibility and competitiveness of each retrofit concept proposed. The results show that the in-depth boiler-turbine integration achieves a better temperature match of heat flows involved for different fluids and multi-stage air preheating, thus a significant improvement of power output (23.99 MW), which is much larger than that of the system with only ORC (6.49 MW). This is mainly due to the limitation of the ultra-low temperature (from 135 to 75 • C) heat available from the flue gas for ORC. The thermodynamic improvement is mostly contributed by the reduction of exergy destruction within the boiler subsystem, which is eventually converted to mechanical power; while the exergy destruction within the turbine system is almost not changed for the three concepts. The selection of ORC working fluids is performed to maximize the power output. Due to the low-grade heat source, the cycle with R11 offers the largest additional net power generation but is not significantly better than the other preselected working fluids. Economically, the in-depth boiler-turbine integration is the most economic completive solution with a payback period of only 0.78 year. The ORC concept is less attractive for a sole application due to a long payback time (2.26 years). However, by coupling both concepts, a net power output of 26.51 MW and a payback time of almost one year are achieved, which may promote the large-scale production and deployment of ORC with a cost reduction and competitiveness enhancement.

show abstract

Identification of optimal operating strategy of direct air-cooling condenser for Rankine cycle based power plants

Cited by 29 publications

References 43 publications

A Review of Evaluation, Optimization and Synthesis of Energy Systems: Methodology and Application to Thermal Power Plants

A Review of Evaluation, Optimization and Synthesis of Energy Systems: Methodology and Application to Thermal Power Plants

Thermal Energy Processes in Direct Steam Generation Solar Systems: Boiling, Condensation and Energy Storage – A Review

Comparative Evaluation of Integrated Waste Heat Utilization Systems for Coal-Fired Power Plants Based on In-Depth Boiler-Turbine Integration and Organic Rankine Cycle

Contact Info

Product

Resources

About