In situ preparation and property investigation of polypropylene/fumed silica nanocomposites

Abstract

We present the preparation of polypropylene (PP)/ fumed silica (FS) nanocomposites via in situ polymerization in this article. The approach includes preparation and utilization of a bisupported Ziegler-Natta catalytic system in which magnesium ethoxide and FS are used as conjugate supports of the catalyst. Catalyst preparation and polymerization processes are carried out in the slurry phase and under argon atmosphere. Scanning electron microscopy images show a good dispersion of the FS throughout the PP matrix. Results from differential scanning calorimetry reveal that the crystallization temperature of prepared nanocomposites increases by increasing FS loading. Also, crystal content of nanocomposites increases as the FS concentration increases up to 3.48 wt%. Nanocomposites containing <3.14 wt% of nanoparticles do not show considerable change in their melting point where with more increment in filler concentration, melting temperature slightly increases. Thermogravimetric analysis shows a considerable improvement in the thermal stability of PP/FS nanocomposites compared to pure PP. Rheological studies indicate that the incorporation of FS into PP matrix results in increment in storage modulus, loss modulus, and complex viscosity of polymeric matrix, particularly in low frequency region. By increasing FS loading, the PP/FS nanocomposites show a transition from liquid-like to solid-like viscoelasticity behavior depicting microstructural changes in their structures. POLYM. COMPOS., 35:37-44,

Thermal and microwave dielectric properties of Cu/polyethylene oxide composite powder prepared by mechanical blending method

“…The magnetic and electrical properties of polypyrrole composite with iron filler attached to acrylamido-2-me thyl-1-propanesulfonic acid were studied by Basavaraja group [20]. The polypropylene composite with fumed silica powder was synthesized by in situ polymerization and analyzed its enhanced thermal stability [21].…”

Fumed silica as a filler for MUPF resin in the process of manufacturing water-resistant plywood

“…A lot of plastics are characterized by insufficient resistance to the action of chemical substances as well as low dimensional stability and mechanical strength at increased temperatures. Introducing nanosilica into polymers, such as linear low-density polyethylene (LLDPE) (Huang et al 2004), polypropylene (Azinfar and Ramazani 2013), epoxy resin (Shirono et al 2001), phenolic resin (Periadurai et al 2010) or into construction materials, for instance polyethersuflone (PES), polyetherketone (PEEK) and polyimide, polyetherimide improves their properties (Sadhan and Sachin 2001). It is manifested by the increase in modulus of elasticity, modulus of rupture, internal bond, impact strength as well as thermal and chemical resistance.…”

Rigid Amorphous Fraction as an Indicator for Polymer-Polymer Interactions in Highly Filled Plastics

“…In the thermograms, which are not shown, it is very difficult to ever detect a glass transition point and to evaluate it reproducibly. Possible reasons for this are that particles not only act as nucleation sites but, if they are sufficiently large, can hinder the crystallization [ 14 , 15 , 27 ].…”