Hydrogel-based heterogeneous-acid-catalysts for converting carbohydrates into the platform chemical: 5-hydroxymethylfurfural

Dharmapriya, Thakshila Nadeeshani; Wu, Shubin; Chang, Ken-Lin; Huang, Po‐Jung

doi:10.1016/j.jtice.2023.104997

Cited by 8 publications

(1 citation statement)

References 88 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…Lignocellulosic biomass is regarded as a promising alternative feedstock for renewable transportation biofuels and bio-based chemicals [ 1 , 2 ]. Depolymerizing cellulose and hemicellulose in a lignocellulosic biorefinery yield hexose (C6-glucose, fructose) and pentose units (C5-xylose).…”

Section: Introductionmentioning

confidence: 99%

Valorization of Glucose-Derived Humin as a Low-Cost, Green, Reusable Adsorbent for Dye Removal, and Modeling the Process

Dharmapriya,

Chang,

Huang

2023

Polymers

Self Cite

View full text Add to dashboard Cite

Glucose can be isomerized into fructose and dehydrated into key platform biochemicals, following the “bio-refinery concept”. However, this process generates black and intractable substances called humin, which possess a polymeric furanic-type structure. In this study, glucose-derived humin (GDH) was obtained by reacting D-glucose with an allylamine catalyst in a deep eutectic solvent medium, followed by a carbonization step. GDH was used as a low-cost, green, and reusable adsorbent for removing cationic methylene blue (MB) dye from water. The morphology of carbonized GDH differs from pristine GDH. The removal efficiencies of MB dye using pristine GDH and carbonized GDH were 52% and 97%, respectively. Temperature measurements indicated an exothermic process following pseudo-first-order kinetics, with adsorption behavior described by the Langmuir isotherm. The optimum parameters were predicted using the response surface methodology and found to be a reaction time of 600 min, an initial dye concentration of 50 ppm, and a GDH weight of 0.11 g with 98.7% desirability. The MB dye removal rate optimized through this model was 96.85%, which was in good agreement with the experimentally obtained value (92.49%). After 10 cycles, the MB removal rate remained above 80%, showcasing the potential for GDH reuse and cost-effective wastewater treatment.

show abstract

Section: Introductionmentioning

confidence: 99%