Hydride formation and stability on a Pd–SiO2 thin-film model catalyst studied by TEM and SAED

Abstract

Hydride formation was studied on Pd particles supported on SiO 2 , and the results were evaluated with reference to a corresponding ZnO-promoted Pd/SiO 2 catalyst reported recently. Pd particles (mean size, ~5 nm) were epitaxially grown on NaCl(001) cleavage faces and subsequently covered by a layer of amorphous SiO 2 , thereby maintaining their epitaxial orientation. The films were subjected to various hydrogen and annealing treatments in the temperature regime of 373-873 K, and their stability in an O 2 environment (373-573 K) was also tested. The structural and morphological changes were followed by transmission electron microscopy and selected area electron diffraction. Reduction at 523 K increased the mean particle size considerably and converted the Pd particles into an amorphous hydride phase that decomposed at and above 673 K either by reduction in hydrogen or by annealing in He environment, forming a crystalline Pd 2 Si phase. Oxidative treatments of the Pd-H phase at temperatures above 523 K induce transformation into partially oriented Pd particles. The Pd 2 Si phase was stable under reductive conditions up to 873 K and decomposed into disoriented Pd particles on oxidation at temperatures at and above 573 K. Although the Pd/SiO 2 catalyst can be readily converted into an amorphous hydride phase, it loses its hydrogen storage capability on entering the silicide state at 673 K, and hence no hydride formation was observed. These results are in contrast to previous observations on a corresponding Pd/ZnO/SiO 2 catalyst, where the formation of a well-ordered PdZn alloy prevented the formation of the hydride phase and significantly enhanced the structural stability of the catalyst and its resistance against sintering. In contrast, the Pd/SiO 2 system was converted into the amorphous hydride state under "real" catalytic conditions, for example, during CO 2 hydrogenation at around 523 K.

Heterogeneous catalytic oxidation of phenol by in situ generated hydrogen peroxide applying novel catalytic membrane reactors

“…The absorbed hydrogen is strongly retained in the metal and is released at 320°C. This temperature is similar to the one reported by other authors [44]. The results also demonstrate that some transformations of the palladium occur as can be concluded from its decreasing capacity for hydrogen storage.…”

“…air, inert gas, hydrogen in [44]. The metal particles have been observed by HRTEM and selected area electron diffraction (SAED).…”

Hydrodechlorination of Light Organochlorinated Compounds and Their Mixtures over Pd/TiO2-Washcoated Minimonoliths

“…Measurements were carried out at 100 °C to avoid the effects of the hydride phases observed by H 2 TPR (Figure ). These phases are usually considered solid solutions of hydrogen, which can interfere with the chemisorption results during the absorption/adsorption of hydrogen . Assuming spherical particles, particle size was calculated as d (nm) = 112/[ D (%)], where D is dispersion. ,, Dispersion decreased and particle size increased on used catalyst samples as compared to fresh ones (Table ).…”