Hybrid railway power quality conditioner for high‐capacity traction substation with auto‐tuned DC‐link controller

Abstract

Power quality was always a major concern in designing an electric supply system for railways. Since electric railcars are usually single-phase loads, they draw high amounts of negative sequence component of currents, in addition to harmonic contents and transient currents. Therefore, many compensation methods were examined to improve the power quality indices. The active power quality conditioner (APQC) can be considered as an ideal compensator for high-speed railway, which contains a three-phase converter connected to the traction substation through a step-down transformer. However, with the growth of railway loads, the nominal rating of the solid-state high-frequency switches of APQC increases seriously, which in turn, results in an exponential growth of the cost of power-electronic switches. Therefore, for a very high-capacity railway system, it is not economic to apply an APQC. As a solution, a combination of APQC with the static VAr compensator is proposed in this study, which reduces the rating of APQC, and improves the power quality of the system. Simulation results validate the pre-defined hypothesis. Moreover, the performance of APQC depends on the DC-link operation, for which genetic-algorithm optimisation has been applied to obtain an optimum design of a stable DC-link voltage.

Energy-Storage-Based Smart Electrical Infrastructure and Regenerative Braking Energy Management in AC-Fed Railways with Neutral Zones

“…However, the capacity of the EPTD for three phase balancer can be much larger than that of the EPTD used for the regenerative power user. The capacity reduction methods of EPTD (mainly RPC) have also been investigated [42][43][44].…”

“…The feasibility of the additional functions of power quality improvement, peak cutting and valley filling, management and control for clean energy, active control for line voltage, and emergency power supply are widely discussed in literatures [5,6,14,[20][21][22][23][24]28,[30][31][32][35][36][37][38][39][40][41][42][43][44]. For the realization process and verification results of those functions, readers can see the above-mentioned literatures.…”

Research on integrated control strategy of doubly‐fed induction generator‐based wind farms on traction power supply system

“…Due to the unique power supply method of the traction power supply system (TPSS) and the complicated operation conditions of the locomotive, the traction load is a typical asymmetric and non-linear load, and a large number of negative sequence and harmonic currents generated by the locomotive during operation flow into the power grid [1][2][3]. Wind farms are generally located in remote areas at the end of the power grid, which is weak.…”

Off‐board and on‐board energy storage versus reversible substations in DC railway traction systems

“…Modern railways feeding systems, similar to other conventional power delivery infrastructures, are rapidly evolving including new technologies and devices [1]. In most of the cases, this evolution relates to the inclusion of modern power electronics and energy storage devices into the networks [2, 3] or in vehicles [4].…”