High thermoelectric conversion efficiency of MgAgSb-based material with hot-pressed contacts

Abstract

The efficiency of heat-to-electricity conversion based on the thermoelectric effect depends on the materials' nondimensional figure of merit zT. While recent years saw an increasing number of reports of large peak zT in thermoelectric materials, efficiency data are scarce. High conversion efficiency requires not only a large average dimensionless figure of merit zT in the operational temperature range, but also good electrical and thermal contacts to the material. In this work, we experimentally demonstrate a record high thermoelectric conversion efficiency of 8.5 % with a single thermoelectric leg based on a recently reported p-type MgAgSb-based compound operating between 20 and 245 °C. The efficiency can exceed 10 % by increasing the hot side temperature to 295 °C. The sample is fabricated with silver contact pads using a one-step hot-press technique eliminating a typically required sample metallization process. This significantly simplifies the fabrication of thermoelectric elements with low electrical and thermal contact resistances.High conversion efficiency is demonstrated at a relatively small temperature difference for a MgAgSb-based single thermoelectric leg with hot-pressed contacts. 73x45mm (150 x 150 DPI)

Lithium Doping to Enhance Thermoelectric Performance of MgAgSb with Weak Electron–Phonon Coupling

“…[ 35 ] More importantly, n-type Mg 2 (Si, Sn) exhibits a high power factor and average ZT from 300 to 548 K along with a modest thermomechanical properties, [ 10,70 ] it is promising to pair p-type MgAgSb with n-type Mg 2 (Si, Sn) when the suitable contacts are found for Mg 2 (Si, Sn) from the current view. Since n-type Mg 2 (Si, Sn) has a low resistivity ≈7 × 10 −6 Ω m at 300 K, [ 10 ] lower resistivity by Li doping [ 33,34,36 ] wileyonlinelibrary.…”

Concentrating solar thermoelectric generators with a peak efficiency of 7.4%

“…3). 30,32,47 The segmented legs are fabricated by soldering the bismuth telluride and skutterudite elements to each other (Fig. 1b).…”

“…26,27 Significant progress has been made on improving and developing new thermoelectric materials in recent years, however actual device demonstrations have been scarce and are mostly motivated by waste heat recovery applications. [28][29][30][31][32][33][34] The auxiliary efficiency in Eq. (1) accounts for possible system parasitic losses such as electricity consumption for pumping and cooling.…”

Achieving high power factor and output power density in p-type half-Heuslers Nb 1-x Ti x FeSb

“…One effective approach to enhance ZT is through nanostructuring that can significantly enhance phonon scattering and consequently result in a much lower lattice thermal conductivity compared with that of the unmodified bulk counterpart (2). This approach works well for many inorganic TE materials, such as Bi 2 Te 3 (2), IV-VI semiconductor compounds (3,4), lead-antimony-silver-tellurium (LAST) (5), skutterudites (6), clathrates (7), CuSe 2 (8), Zintl phases (9), half-Heuslers (10-12), MgAgSb (13,14), Mg 2 (Si, Ge, Sn) (15,16), and others.…”