High-temperature creep constitutional model of Q460E steel and effect of creep on bulging deformation of continuous casting slab

Guo, Long; Sui, Yunhuan; Zhang, Xingzhong

doi:10.1007/s42243-018-0169-1

Cited by 6 publications

(1 citation statement)

References 16 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…to prevent the molten steel from spilling [13]. Referring to the previous study [14], the tensile stress value was set below the yield stress so that merely the creep strain could be obtained rather than the plastic strain. The parameters of the tensile creep test are listed in Table 2.…”

Section: High Temperature Tensile Creep Testmentioning

confidence: 99%

Microstructural Study of High Temperature Creep in Q460E Steel Based on the Solidification Method

Sui

Zhang

Guo³

et al. 2020

TFAMENA

Self Cite

View full text Add to dashboard Cite

A tensile creep test has been carried out to study the high temperature creep mechanism of Q460E steel and thus develop a better understanding about how the creep phenomenon affects the performance of a cast slab. Because the heating process in the solidification method is more similar to the actual solidification process of casting a slab, the high temperature tensile creep test was conducted by using the solidification method. Further observation of the microstructure was carried out after the tensile creep test has been carried out. The microstructure of the Q460E steel after the high temperature tensile creep test and water quenching observed with a metallographic microscope revealed mainly martensite and retained austenite. From the observation with a transmission electron microscope (TEM) it could be found that dislocation and its substructure were the root cause which triggered high temperature creep deformation of the Q460E steel. In addition, the formation of a subboundary also provided the impetus to creep deformation.

show abstract

Section: High Temperature Tensile Creep Testmentioning

confidence: 99%