High‐grade metamorphism and partial melting in Archean composite grey gneiss complexes

The recent development of activity–composition relations for mineral and melt phases in high‐grade metamafic rocks allows mineral equilibria tools to be used to further aid our understanding of partial melting and the mineralogical consequences of melt segregation in these rocks. We show that bulk compositional data from natural amphibolites cover a wide compositional range, with particular variability in the content and ratios of Ca, Na and K indicating that low‐grade metasomatic alteration can substantially alter the igneous protolith chemistry and potentially affect the volume and composition of melt generated. Mineral equilibria calculations for five samples that span the compositional variability in our data set indicate that melting occurs primarily via the fluid‐absent breakdown of amphibole+quartz to produce a pressure‐sensitive peritectic assemblage of augite, orthopyroxene and/or garnet. The introduction of orthopyroxene at the onset of the amphibolite‐to‐granulite‐facies transition at lower pressure results in an increased rate of melt production until quartz is typically exhausted, and this is similarly seen for the introduction of garnet at higher pressure. Calculated melt compositions are dependent on the protolith composition, but initial solidus melting and biotite breakdown produce 1–3 mol.% of K‐rich granitic melts. As hornblende melting proceeds, 15–20 vol.% of either more granodioritic‐to‐tonalitic or granodioritic‐to‐trondhjemitic melt is produced. Once quartz is exhausted, intermediate to mafic melt compositions are produced at ultrahigh‐temperature conditions. Quartz‐rich lithologies with high Ca coupled to low Na and K are the most fertile under orogenic conditions, yielding up to 25 mol.% of sub‐alkalic granitic melt by 850°C. Such rocks did not experience significant subsolidus alteration. Altered compositions with low Ca and elevated Na and K are not as fertile, yielding less than 15 mol.% of alkalic granitic melt by 850°C. These melt volumes are enough to be segregated, and can make a contribution to granite magmatism and intracrustal differentiation that should not be overlooked.

Section: Discussionsupporting

confidence: 89%

Section: Discussionmentioning

confidence: 99%

See 1 more Smart Citation

Mineral equilibria constraints on open‐system melting in metamafic compositions

Stuck

Diener

2018

“…These relations now allow for in‐depth, quantitative investigation of granulite facies metamorphism in the early Earth, and the formation and long‐term evolution of Archean continental crust (e.g. Johnson, Brown, Gardiner, Kirkland, & Smithies, ; Palin, White, & Green, ; White et al., ).…”

Section: Introductionmentioning

confidence: 99%

New constraints on granulite facies metamorphism and melt production in the Lewisian Complex, northwest Scotland

Feisel

White

Palin

et al. 2018

In this study, we investigate the metamorphic history of the Assynt and Gruinard blocks of the Archean Lewisian Complex, northwest Scotland, which are considered by some to represent discrete crustal terranes. For samples of mafic and intermediate rocks, phase diagrams were constructed in the Na2O–CaO–K2O–FeO–MgO–Al2O3–SiO2–H2O–TiO2–O2 (NCKFMASHTO) system using whole‐rock compositions. Our results indicate that all samples equilibrated at similar peak metamorphic conditions of ~8–10 kbar and ~900–1,000°C, consistent with field evidence for in situ partial melting and the classic interpretation of the central region of the Lewisian Complex as representing a single crustal block. Melt‐reintegration modelling was employed in order to estimate probable protolith compositions. Phase equilibria calculated for these modelled undepleted precursors match well with those determined for a subsolidus amphibolite from Gairloch in the southern region of the Lewisian Complex. Both subsolidus lithologies exhibit similar phase relations and potential melt fertility, with both expected to produce orthopyroxene‐bearing hornblende granulites, with or without garnet, at the conditions inferred for the Badcallian metamorphic peak. For fully hydrated protoliths, prograde melting is predicted to first occur at ~620°C and ~9.5 kbar, with up to 45% partial melt predicted to form at peak conditions in a closed‐system environment. Partial melts calculated for both compositions between 610 and 1,050°C are mostly trondhjemitic. Although the melt‐reintegrated granulite is predicted to produce more potassic (granitic) melts at ~700–900°C, the modelled melts are consistent with the measured compositions of felsic sheets from the central region Lewisian Complex.

“…Brown, ; Chakraborty et al., ; Chambers et al., ; Spear, Pattison, & Cheney, ; and many more), with fewer examples of their application to Archean settings (notable exceptions include e.g. Bhadra & Nasipuri, ; Bhowmik, Wilde, Bhandari, & Basu Sarbadhikari, ; Cutts et al., ; Dumond, Goncalves, Williams, & Jercinovic, ; François, Philippot, Rey, & Rubatto, ; Nicoli, Stevens, Moyen, & Frei, ; White, Palin, & Green, ) to reveal the P−T– t paths that Archean HT rocks took through the crust. Several key questions can be answered from the metamorphic archive and would shed light on heating mechanisms in the Archean crust and Archean tectonic processes.…”

Section: Introductionmentioning

confidence: 99%

Rapid high‐T decompression recorded by Archean granulites in the northern Wyoming Province: Insights from petrological modelling

Guevara

Caddick

Dragovic

2017

This study places new constraints on the pressure–temperature (P–T) path and duration of high‐temperature (HT) metamorphism recorded by Archean granulite facies metasedimentary rocks from the northern Wyoming Province in the eastern Beartooth Mountains, MT and WY, USA. These rocks exist as m‐ to km‐scale xenoliths within a c. 2.8 Ga calc‐alkaline granitoid batholith. Different interpretations of the timing of HT metamorphism relative to batholith intrusion in previous works have led to ambiguity over the mechanism by which these rocks were heated (i.e. batholith intrusion v. a later, cryptic event). The P–T path recorded by these rocks and the duration of this path may be indicative of the heating mechanism but are not currently well constrained. Here, we combine phase equilibria thermobarometry and diffusion modelling of major element zonation in garnet in order to constrain the P–T path of HT metamorphism and the durations of different parts of this path. It is shown that these rocks record a tight, clockwise P–T path characterized by near‐isobaric heating at ~6.5–7 kbar to ˜770–800°C, HT decompression to ~6 kbar, 780–800°C, followed by limited decompression while cooling. Diffusion modelling of major element zonation in garnet suggests that HT decompression was brief (likely <1 Ma), and that cooling rates following this decompression were on the order of 10–100°C/Ma. Substantial changes in apparent thermal gradient along this P–T path indicate that the rocks record a significant but short‐lived thermal anomaly that occurred in the Wyoming mid‐crust in the Late Archean.