High-Density Nanoporous carbon materials as storage material for Methane: A value-added solution

Memetova, A. E.; Tyagi, Inderjeet; Karri, Rama Rao; Suhas, .; Memetov, N. R.; Zelenin, A. D.; Stolyarov, R. A.; Babkin, Alexander V.; Yagubov, V. S.; Бурмистров, И. Н.; Ткачев, А. Г.; Bogoslovskiy, Vladimir; Shigabaeva, Gulnara; Galunin, Evgeny

doi:10.1016/j.cej.2022.134608

Cited by 20 publications

(7 citation statements)

References 52 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…[8]. Nevertheless, their performance has been comparable to the best performing MOFs due to which they remain potential materials for application [9,10].…”

Section: Introductionmentioning

confidence: 99%

Temperature based Enhanced Desorption of Adsorbed Biomethane Stored on Sustainable Nanoporous Materials

Adlak

Chandra

Vijay

et al. 2022

IOP Conf. Ser.: Earth Environ. Sci.

View full text Add to dashboard Cite

In recent years, adsorbed natural gas storage has been seen as a better alternative to storing methane-rich gas on porous materials. Especially when these porous materials can be derived from a source like biomass whole process becomes valuable development. However, the problem of lower delivery capacity and the amount of gas released upon releasing the pressure remains unsolved. The micropores developed on the activated carbons retain the gas as they cannot get the activation energy to detach from the surface. The thermodynamics of the desorption process discourages the overall technological development of the system. We have carried out studies under particular temperatures by placing material and gas-filled cylinder in a water bath to overcome this challenge. Coconut based activated carbons were used in the study, which were procured from the market. Adsorption isotherm and other characteristics were performed for activated carbons. The desorption amount of the gas was recorded for different temperatures of 40, 45, 50 and 55 °C. At room temperature, nearly 54% of adsorbed gas is being released. Whereas, at 55 °C, approximately 80% of the gas is being recovered. This work will be useful for the externally cylinder fitted vehicles where the exhaust stream can be channelised to warm the surrounding of the cylinder to facilitate the higher discharge of the adsorbed gas.

show abstract

“…[8]. Nevertheless, their performance has been comparable to the best performing MOFs due to which they remain potential materials for application [9,10].…”

Section: Introductionmentioning

confidence: 99%

Temperature based Enhanced Desorption of Adsorbed Biomethane Stored on Sustainable Nanoporous Materials

Adlak

Chandra

Vijay

et al. 2022

IOP Conf. Ser.: Earth Environ. Sci.

View full text Add to dashboard Cite

show abstract

“…23,24 Porous carbons, on the other hand, are more amenable to densification/compaction with retention of porosity and gravimetric gas uptake. 26–31 Alternative approaches have explored the use of binders to improve the packing density of porous carbons, 32 or the synthesis of monolithic forms of activated carbons. 33…”

Section: Introductionmentioning

confidence: 99%

“…23,24 Porous carbons, on the other hand, are more amenable to densification/compaction with retention of porosity and gravimetric gas uptake. [26][27][28][29][30][31] Alternative approaches have explored the use of binders to improve the packing density of porous carbons, 32 or the synthesis of monolithic forms of activated carbons. 33 Despite a great deal of on-going and previous research, there appears to be a limit to the packing density (and consequently volumetric gas uptake) that can be achieved by MOFs and purely carbonaceous carbons.…”

Section: Introductionmentioning

confidence: 99%

Porous carbon composites as clean energy materials with extraordinary methane storage capacity

Alali,

Shehu,

Mokaya

2024

Energy Environ. Sci.

View full text Add to dashboard Cite

show abstract

“…Therefore, solid-state materials are considered as promising storage media due to their properties such as high surface area, low density, and high thermal and chemical stability compared to compressed and liquefied storage systems. [13][14][15] Various porous solids such as silica, zeolites, activated carbon, carbon nanotubes, fullerenes, graphene and composites of these materials have been used for the storage of gaseous fuels with improved storage capacity. 16,17 Nevertheless, these materials suffer from slow kinetics, poor reversibility, energy-intensive synthesis and poor reproducibility in storage capacity.…”

Section: Introductionmentioning

confidence: 99%

Metal–organic frameworks (MOFs) for energy production and gaseous fuel and electrochemical energy storage applications

Shanmugam,

Agamendran,

Sekar

et al. 2023

Phys. Chem. Chem. Phys.

View full text Add to dashboard Cite

show abstract

High-Density Nanoporous carbon materials as storage material for Methane: A value-added solution

Cited by 20 publications

References 52 publications

Temperature based Enhanced Desorption of Adsorbed Biomethane Stored on Sustainable Nanoporous Materials

Temperature based Enhanced Desorption of Adsorbed Biomethane Stored on Sustainable Nanoporous Materials

Porous carbon composites as clean energy materials with extraordinary methane storage capacity

Metal–organic frameworks (MOFs) for energy production and gaseous fuel and electrochemical energy storage applications

Contact Info

Product

Resources

About