Helium-Neon Laser Effects on Human Whole Blood by Spectroscopy In vitro Study

Haimid, Mohammed Ali; Marouf, Ali A. S.; Abd-Alla, Mubarak Dirar

doi:10.9734/ajopacs/2019/46214

Cited by 4 publications

(5 citation statements)

References 0 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…Radio and laser EMW are used in telecommunication, where the transmit information through the internet to mobile phones and computers [2]. Laser is used also in medicine in surgery and curing some diseases, beside other biological applications [3]. The utilization of EMW in telecommunication is the most commercially important to people.…”

Section: Introductionmentioning

confidence: 99%

See 1 more Smart Citation

Electronic Chips Act as Capacitors or Inductors When Lasers Act as an Information Transmitter

Yousef¹,

Alsubaie²,

Saad³

et al. 2022

Preprint

View full text Add to dashboard Cite

To increase the network computer and mobile telephone capacity one needs a laser to carry information instead of electrons. Since the laser is very fast compared to electrons, one expects information to be transmitted very fast through the network (internet). This requires searching for chips that act as capacitors, inductors, or evens as resistors this work shows that the laser traveling beam diminished as the frequency reciprocal thus acts as a capacitor or diminished as frequency thus acts as an inductor and sometimes diminished with the concentration of carriers thus act as a resistor for magnetic materials with strength that cancels the friction force when the laser frequency is equal nearly to the atoms natural frequency the material act as an inductor. Then frictional force is dominant with high mobility dielectric, the material acts as a capacitor. However, it acts as a conductor for negligible friction and natural frequency.

show abstract

Section: Introductionmentioning

confidence: 99%

“…Different attempts were made to utilize laser in storing and transmitting information [6,7,8]. The work done by Christopher Monroe [3] speak about using laser in quantum computer to control floating atoms. This will enable computers to perform many calculations within almost no time.…”

Section: Introductionmentioning

confidence: 99%

Electronic Chips Act as Capacitors or Inductors When Lasers Act as an Information Transmitter

Yousef¹,

Alsubaie²,

Saad³

et al. 2022

Preprint

View full text Add to dashboard Cite

show abstract

“…There have been numerous research studies the effect of laser matter irradiation; for example, laser milk pasteurization (Marouf and Sara, 2018;Amna and Marouf, 2018), solar cell surface modification (Marouf et al, 2014, Islam et al, 2020, bee honey irradiation (Al Humira and Marouf, 2017) and production of highly value materials from agricultural waste (Gawbah et al, 2017;Gawbah et al, 2018). There have been numerous research studies the interaction of lowlevel lasers with biological materials such as blood; for examples; studding of He-Ne laser effect on human whole blood (Haimid et al, 2019a), investigating the effect of He-Ne laser on human whole blood (Haimid et al, 2019b), and it also used to induce emission in human teeth to distinguish www.universepg.com l UniversePG between dental caries and sound teeth (Marouf and Khairallah, 2019).…”

Section: Introductionmentioning

confidence: 99%

Influence of High Power Nd: YAG Laser on Hardness and Surface Properties of Zirconium Silicate

2020

IJMMS

View full text Add to dashboard Cite

Different parameters like irradiated area, irradiation time, laser wavelength, pulse energy, and the nature of the irradiated material determine largely the effect of the laser-matter interaction. In this, study the influence of high power Nd: YAG laser irradiation on the hardness and surface properties of zirconium silicate (ZrSiO4) ceramics was investigated. Specimens of zirconium ceramic pieces were divided into four samples depend on irradiation duration as follows: one reference sample and three samples treated with Nd: YAG laser at irradiation times vary from 3 to 5 minutes. The irradiation was done with 60 W output power. The hardness and tensile strength were determined and the optical properties were characterized by UV-vis spectroscopy, also EDX spectra were carried out. The obtained results revealed that high power (60 W) Nd: YAG laser provides higher hardness compared to the reference sample surface. Increasing irradiation time resulted in the higher hardness of the ceramic surfaces. EDX results showed that laser irradiation does not change the chemical surface composition of ceramics. Moreover, an increase in transmittance of the irradiated zirconium silicate in the visible and near-infrared range was also found using UV-vis spectroscopy.

show abstract

mentioning

confidence: 99%

“…The work done by Christopher Monroe [3] speak about using laser in quantum computer to control floating atoms. This will enable computers to perform many calculations within almost no time.…”

mentioning

confidence: 99%

Electronic Chips Acting as Capacitors or Inductors when Laser Act as Information Transmitter

Yousef

Alsubaie

Saad

et al. 2022

EEJP

View full text Add to dashboard Cite

To increase the speed of information flow and storage capacity in electronic devices laser can be used to carry information instead of electric current. Since the photon is faster than electrons, one expects information to be transmitted very fast through the internet when photons replace electrons. This requires searching for chips that act as capacitors, inductors or resistors. To do this Maxwell's equation for the electric field intensity beside the electron equation of motion were used. The electron is assumed to vibrate naturally inside a frictional medium in the presence of a local electric and magnetic fields. These equations have been used to find a useful expression for the absorption coefficient. The absorption coefficient was found to be dependent on the laser and natural frequencies beside the coefficient of friction in addition to the internal electric and magnetic fields. These parameters can be fine-tuned to make the chip act as a capacitor, inductor or resistor. The laser intensity decreases when the absorption coefficient inecreases. Thus, the absorption coefficient acts as an electic resistor. Therefore, if the absorption coefficient inecreases upon decreasing the frequency the chip acts as a capacitor. But when the absorption coefficient inecreases when the laser frequency inreases the chip acts as an inductor. In the case that the absorption coefficient inecreases with the concentration of the carriers it acts in this situation as a resistor. For magnetic materials with magnetic flux density that cancels the frictional force, when the laser frequency is equal nearly to the atom’s natural frequency the material acts as an inductor. But when the frictional force is low with the internal and external electric fields in phase, the material acts as a capacitor. However, it acts as a resistor for negligible natural frequency, when no electric dipoles exist and when the internal magnetic field force balance the frictional force.

show abstract

Helium-Neon Laser Effects on Human Whole Blood by Spectroscopy In vitro Study

Cited by 4 publications

References 0 publications

Electronic Chips Act as Capacitors or Inductors When Lasers Act as an Information Transmitter

Electronic Chips Act as Capacitors or Inductors When Lasers Act as an Information Transmitter

Influence of High Power Nd: YAG Laser on Hardness and Surface Properties of Zirconium Silicate

Electronic Chips Acting as Capacitors or Inductors when Laser Act as Information Transmitter

Contact Info

Product

Resources

About