Hele-Shaw rheometry

Abstract

SynopsisIn this paper, we describe a novel approach to determine the flow behavior index of a power-law fluid by means of a microfluidic device. The concept of this method is based on a mathematical analysis by Aronsson and Janfalk [Eur. J. Appl. Math. 3, 343-366 (1992)] of Hele-Shaw flow of power-law liquids. We implement this approach by driving a non-Newtonian fluid through a glass microfluidic chip with a 100:1 contraction. The flow in this chip satisfies the Hele-Shaw flow conditions in most of the device. Two conjugate p-Laplace equations describe the pressure and stream function in such flows. These equations depend on the flow behavior index, n. Therefore, by fitting the p-Laplace equation to the velocity field obtained from a micro particle image velocimetry measurement of the flow, the flow behavior index of the fluid in the chip can be determined. Because in practice, fluids rarely show perfectly inelastic power-law behavior, conditions under which the assumption of inelastic flow is valid were derived by analyzing Hele-Shaw flow of an Oldroyd-B fluid. The concept was tested using three different classes of model fluids, a Newtonian fluid, an inelastic power-law fluid, and a Boger fluid. In all three cases, satisfactory results were obtained, with values of n deviating at most 4% from values measured using conventional rheometry. The method presented here is expected to be potentially useful in online quality control in, for example, polymer or food processing. V C 2013 The Society of Rheology. [http://dx

Obstructed viscoplastic flow in a Hele-Shaw cell

“…However, no asymmetry is observed for PEO, a result that extends to a range of flow rates and polymer concentrations. On further consideration [14], the absence of fore-aft asymmetry in this viscoelastic flow is not surprising: for the sheared flow in the narrow geometry of our Hele-Shaw cell, the extensional stresses are suppressed and the Weissenberg number is relatively small [typical shear rates are 0. scales comparable to the height of the slot (here H ∼ 1 mm, which is comparable in size to the discrepancy between theory and experiment) or by the complications in defining the edge of the plug due to undetectable velocities. Such possibilities cannot, however, rationalize the second difference between the Carbopol and earlier tests, which is that there is a marked fore-aft asymmetry in the flow pattern, with the plug at the front being larger than that at the rear, and mirrors findings for unconfined flows [7,8].…”

Interplay of physical mechanisms and biofilm processes: review of microfluidic methods

“…In the past decade, microfluidics has been an integral part of rheometry techniques [116] and various microdevices have been developed to probe the mechanical properties of human blood plasma [117], circulating cells [118], Newtonian and non-Newtonian liquids [119], power-law fluids [120], etc. However, few microfluidic rheometers are specialized to measure the rheological characteristics of bacterial biofilms.…”

Ultrasound Imaging Velocimetry: a review

“…While the flow in this figure only has a streamwise (lateral in the measurement frame) component, UIV can also characterise, for instance, the flow encountering a sudden diameter change . This opens up more sophisticated methods to establish rheological parameters (Drost and Westerweel 2013). Ultrasound-based velocimetry has also been successfully applied in Taylor-Couette flows, for more fundamental rheology studies (Manneville et al 2004).…”