Heat transfer from round impinging jets to a flat plate

Hrycak, P.

doi:10.1016/s0017-9310(83)80156-2

Cited by 96 publications

(26 citation statements)

References 3 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…It may be postulated that this result can be used for submerged jets at the stagnation point. Exponent of 0.4 has been widely accepted for gas [8,12,[14][15][16][17], water[7,S,lS-21], freon [22,23] and fluorocarbon [7] with Prandtl number less than 20.…”

Section: Heat Transfer At Stagnation Pointmentioning

confidence: 99%

Local convective heat transfer from small heaters to impinging submerged axisymmetric jets of seven coolants with Prandtl number ranging from 0.7 to 348

Sun

YiShui

1997

J. of Therm. Sci.

View full text Add to dashboard Cite

show abstract

Section: Heat Transfer At Stagnation Pointmentioning

confidence: 99%

Local convective heat transfer from small heaters to impinging submerged axisymmetric jets of seven coolants with Prandtl number ranging from 0.7 to 348

Sun

YiShui

1997

J. of Therm. Sci.

View full text Add to dashboard Cite

show abstract

“…They also studied the heat transfer distribution due to impingement of multiple two-dimensional jets. Gardon and Akfirat (1966), Baughn and Shimizu (1989) and Hrycak (1983) have conducted experiments of heat transfer to round jet from flat plate employing different methods of surface temperature measurement. Lytle and Webb (1994) have studied the effect of very low nozzleto-plate spacing (z/d < 1) on the local heat transfer distribution on a flat plate impinged by a circular air jet issued by long pipe nozzle which allows for fully developed flow at the nozzle exit.…”

Section: Introductionmentioning

confidence: 99%

Heat transfer enhancement on a flat surface with axisymmetric detached ribs by normal impingement of circular air jet

Katti

Prabhu

2008

International Journal of Heat and Fluid Flow

View full text Add to dashboard Cite

“…The literature on heat transfer and flow of impinging jets is vast and growing [Martin, 1977;Downs and James, 1987;Hrycak, 1981;Webb and Ma, 1995;Lee and Lee, 2000]. The primary application has been for enhancement of convective heat transfer parameters [Gardon and Akfirat, 1965] so much of the literature concentrated on integral heat transfer quantities, such as local or average heat transfer coefficients (e.g., Goldstein and Behbahani [1982], Hrycak [1983], Baughn and Shimizu [1989], Liu and Lienhard [1993], San, Huang and Shu [1997], , Siba et al [1998], Lee and Lee [2000] Behnia et al [1999] and others. To maintain effectiveness, often arrays of impinging jets are employed with small pitch-to-diameter spacings, so the non-dimensional radial extent is not large [Womac, Incropera and Ramadyani, 1994;Slayzak, Viskanta and Incropera, 1994;Lienhard et al, 1996].…”

Section: Experimental Needsmentioning

confidence: 99%

Development Of An Experiment For Measuring Flow Phenomena Occurring In A Lower Plenum For VHTR CFD Assessment

McEligot¹,

Condie²,

Creery³

et al. 2005

View full text Add to dashboard Cite

The objective of the present report is to document the design of our first experiment to measure generic flow phenomena expected to occur in the lower plenum of a typical prismatic VHTR (Very High Temperature Reactor) concept. In the process, fabrication sketches are provided for the use of CFD (computational fluid dynamics) analysts wishing to employ the data for assessment of their proposed codes. The general approach of the project is to develop new benchmark experiments for assessment in parallel with CFD and coupled CFD/systems code calculations for the same geometry. One aspect of the complex flow in a prismatic VHTR is being addressed: flow and thermal mixing in the lower plenum ("hot streaking" issue). Current prismatic VHTR concepts were examined to identify their proposed flow conditions and geometries over the range from normal operation to decay heat removal in a pressurized cooldown. Approximate analyses were applied to determine key non-dimensional parameters and their magnitudes over this operating range. The flow in the lower plenum can locally be considered to be a situation of multiple jets into a confined crossflow --with obstructions. Flow is expected to be turbulent with momentum-dominated turbulent jets entering; buoyancy influences are estimated to be negligible in normal full power operation. Experiments are needed for the combined features of the lower plenum flows. Missing from the typical jet experiments available are interactions with nearby circular posts and with vertical posts in the vicinity of vertical walls -with near stagnant surroundings at one extreme and significant crossflow at the other.Unheated MIR (Matched-Index-of-Refraction) experiments are first steps when the geometry is complicated. One does not want to use a computational technique which will not even handle constant properties properly. The purpose of the fluid dynamics experiments is to develop benchmark databases for the assessment of CFD solutions of the momentum equations, scalar mixing and turbulence models for typical VHTR plenum geometries in the limiting case of negligible buoyancy and constant fluid properties. As indicated by the scaling studies, in normal full power operation of a typical VHTR conceptual design, buoyancy influences should be negligible in the lower plenum. The MIR experiment will simulate flow features of the paths of jets as they mix in flowing through the array of posts in a lower plenum en route to the single exit duct. The conceptual design for such an experiment is described and the development of the final apparatus is presented. Fabrication sketches are provided in Appendix A for the use of CFD analysts wishing to employ the data for assessment of their proposed codes. iv v

show abstract

Heat transfer from round impinging jets to a flat plate

Cited by 96 publications

References 3 publications

Local convective heat transfer from small heaters to impinging submerged axisymmetric jets of seven coolants with Prandtl number ranging from 0.7 to 348

Local convective heat transfer from small heaters to impinging submerged axisymmetric jets of seven coolants with Prandtl number ranging from 0.7 to 348

Heat transfer enhancement on a flat surface with axisymmetric detached ribs by normal impingement of circular air jet

Development Of An Experiment For Measuring Flow Phenomena Occurring In A Lower Plenum For VHTR CFD Assessment

Contact Info

Product

Resources

About