Heat Transfer at Mixed Convection in Vertical and Inclined Flat Channels of the Vacuum Chamber of the ITER International Thermonuclear Reactor

Balunov, B. F.; Babykin, A. S.; Rybin, R. A.; Krylov, V. A.; Tanchuk, V.; Grigor’ev, S. A.

doi:10.1023/b:hite.0000020100.11937.3f

Cited by 2 publications

(2 citation statements)

References 3 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…Heat transfer and fluid flows driven by natural convection in open channels have been extensively studied over the last past decades, for vertical or inclined configurations. This great interest raised by this subject stems from its wide range of practical applications such as solar chimney, solar energy collectors, Trombe walls, or the cooling of electronic components and many others [1][2][3][4].…”

Section: Introductionmentioning

confidence: 99%

Benchmark solutions for natural convection flows in vertical channels submitted to different open boundary conditions

Desrayaud¹,

Chénier²,

Joulin³

et al. 2013

International Journal of Thermal Sciences

View full text Add to dashboard Cite

International audienceComparison exercises have been carried out by different research teams to study the sensitivity of the natural convection occurring in a vertical asymmetrically heated channel to four sets of open boundary conditions. The dimensionless parameters have been chosen so that a return flow exists at the outlet. On the whole, results provided by the partners are in good agreement; benchmark solutions are then defined for each of the boundary conditions. Whilst the local and average Nusselt numbers based on the entrance temperature do not depend much on conditions applied in the aperture sections, the net fluid flow rates crossing the channel and the characteristics of the recirculation cells are highly influenced. But we proved that these modifications of flow patterns do not alter significantly the fluid flow rates leaving the channel through the exit section

show abstract

Section: Introductionmentioning

confidence: 99%

Benchmark solutions for natural convection flows in vertical channels submitted to different open boundary conditions

Desrayaud¹,

Chénier²,

Joulin³

et al. 2013

International Journal of Thermal Sciences

View full text Add to dashboard Cite

show abstract

“…However, reference results for mixed convection are relatively sparse in comparison with those for forced or natural convection flows in ducts. That is due to the large increase in the complexity and numbers of possible flow configurations occurring in practical applications: cooling of electronic equipment, solar energy collectors, compact heat exchangers and many others [1].…”

mentioning

confidence: 99%

Optimal plate spacing for mixed convection from an array of vertical isothermal plates

Sun

Chénier

et al. 2012

International Journal of Thermal Sciences

View full text Add to dashboard Cite

Numerical simulations of mixed convection of air between vertical isothermal surfaces were conducted in order to determine the optimum spacing corresponding to the peak heat flux transferred from an array of isothermal, parallel plates cooled by mixed convection. Comparisons between approximate analytical solutions for natural and forced convection are first discussed. It is shown that the agreement is fairly good. From the computations carried out for aiding mixed convection by assuming a pressure drop at the outlet section rather than a constant flow rate, it is numerically predicted that the optimum spacing is smaller than those for pure natural or pure forced convection. This spacing is determined according to the pressure drop. As a sample, we considered an array of 10 cm-height, isothermal surfaces at temperature T h = 340 K with air as the working fluid entering into the channels at T 0 = 300 K. The increases in heat flux corresponding to the optimal spacing are discussed for outlet pressure drops ranging from −0.1 P a to −1 P a. Such a range covers the entire mixed convection regime for this specific application.

show abstract

Heat Transfer at Mixed Convection in Vertical and Inclined Flat Channels of the Vacuum Chamber of the ITER International Thermonuclear Reactor

Cited by 2 publications

References 3 publications

Benchmark solutions for natural convection flows in vertical channels submitted to different open boundary conditions

Benchmark solutions for natural convection flows in vertical channels submitted to different open boundary conditions

Optimal plate spacing for mixed convection from an array of vertical isothermal plates

Contact Info

Product

Resources

About