Harmonic Compensation using STATCOM for SEIG Feeding Single-Phase Load Connected between Different Phases

Gorantla, Satyanarayan; Kumar, G. Ravi

doi:10.11591/ijeecs.v6.i3.pp489-496

Cited by 2 publications

(2 citation statements)

References 9 publications

(9 reference statements)

Supporting

Mentioning

Contrasting

Order By: Relevance

“…Leakage current of DC incline plane test can be evaluated and can show the surface condition for the insulator [20]. There are also several other methods that can be shown by using the leakage current waveform obtain such as using total harmonic distortion as mention in [21][22][23][24].…”

Section: Results From DC Incline Plane Test (Ipt)mentioning

confidence: 99%

DC inline plane test of silicone rubber samples with different filler for high-voltage insulation

Norddin

Saadon

Kamarudin

et al. 2020

IJEECS

View full text Add to dashboard Cite

<span>This paper is about preparation of silicone rubber (SiR) samples with different filler for high-voltage insulation purpose. The fillers used were silica from waste glass, calcium carbonate from cockle shell, silica/calcium carbonate and wollastonite. All the fillers were crushed into powder and undergo internal mixer and hot press as a material preparation. It was expected that the combination of filler with silicone rubber would give better result when experiencing ageing process. The direct current (DC) inclined plane test was used to investigate the tracking and erosion on silicone rubber composites. The tracking length was observed between the top and bottom electrode. Comparison would then be made between the silicone rubbers with different fillers based on the result obtained from the experiment.</span>

show abstract

Section: Results From DC Incline Plane Test (Ipt)mentioning

confidence: 99%

DC inline plane test of silicone rubber samples with different filler for high-voltage insulation

Norddin

Saadon

Kamarudin

et al. 2020

IJEECS

View full text Add to dashboard Cite

show abstract

“…In the field of reactive power compensation technology, Static Synchronous Compensator (STATCOM) has been developed to regulate reactive power flow between the network and the capacitor/battery [10][11][12]. Likewise, in energy storage technology, STATCOM is also used to regulate active power flow between the network and electrical energy storage components [13][14].…”

Section: Introductionmentioning

confidence: 99%

Analysis of Electronic Load Controller with Bidirectional Converter in Self-Excited Induction Generator

Pawowoi

Muslyadi

Nazir

et al. 2022

JNTE

View full text Add to dashboard Cite

Induction generators are widely used in small-scale power plants driven by renewable energy, such as wind, mini/micro-hydro, tidal wave, biomass, biogas, etc. In applying this generator to a micro-hydropower plant, it is usually equipped with an ELC (Electronic Load Controller), which regulates the frequency to remain constant at a safe tolerance limit (49.8 – 50.2 Hz). However, this system is still not optimal because the ELC dumps its excess power into the dummy load. This paper proposes an ELC system that can adjust the frequency to remain constant without wasting excess power from the generator. This system uses the working principle of a bidirectional converter, which can regulate the flow of power from the generator and dummy load in two directions. In the proposed system, the dummy load uses a battery to store excess electrical energy and be utilized and reused when needed. Performance analysis of the proposed system uses simulation with MATLAB Simulink software. The induction generator used has a voltage specification of 380 Y, 50 Hz, 1420 rpm, 3.5 A, and 1.5 kW. The analysis results show that the developed ELC design can adjust the frequency in the value range of 49.98-50.01 Hz during load changes with a range of 955 Watt to 1.045 Watt, with the response time reaching its steady-state value of 0.1-0.4 seconds.

show abstract

Harmonic Compensation using STATCOM for SEIG Feeding Single-Phase Load Connected between Different Phases

Abstract: The paper presents the analysis of harmonic distortion when non-linear load is connected in different phases of power system with STATCOM for singly excited induction generator system with wind turbine as prime mover. Now-a-days

Cited by 2 publications

References 9 publications

DC inline plane test of silicone rubber samples with different filler for high-voltage insulation

DC inline plane test of silicone rubber samples with different filler for high-voltage insulation

Analysis of Electronic Load Controller with Bidirectional Converter in Self-Excited Induction Generator

Contact Info

Product

Resources

About