Gluteus Maximus Transfer following Total Hip Arthroplasty Does Not Improve Abductor Moment: A Case-Control Gait Analysis Study of 15 Patients with Gluteus Medius Disruption

Abstract

Gluteus maximus flap transfer (GMT) is a surgical technique used to improve gait kinematics and kinetics, as well as to reduce and ameliorate the functional outcome in patients with hip abductor deficiency following total hip arthroplasty (THA). The purpose of this observational study was to evaluate the gait pre- and postoperatively and examine whether GMT increases the abduction moment. Materials and Methods: A gait analysis based on reflective markers and force plates was performed in 15 patients who underwent GMT and were examined using an optical tracking system before and at a minimum of 13 months after the operation. The median follow-up time was 24 (13–60) months. The primary outcome was hip abduction moment (Nm/kg) during gait. The control group consisted of 15 female subjects without any gait pathology. Results: The mean adduction moment was significantly higher compared with controls before the operation (p = 0.02), but this did not apply to the abduction moment (p = 0.60). At the group level, the abduction moment did not improve postoperatively (p = 0.30). Only six of fifteen patients slightly improved their hip abduction moment postoperatively. However, speed (0.74 to 0.80 m/s) and cadence (94 to 105 steps/min) were improved (p < 0.03). Discussion: The results of this study showed no improvement in the hip abduction moment after GMT surgery. In our experience, abduction deficiency following primary THA is still a difficult and unsolved problem.

Periprosthetic joint infection after total hip arthroplasty induces histological degeneration of the gluteus medius tendon

“…6,7 Gait deficiency originating from the hip is often related to the gluteus medius tendon (GMED) and muscle infirmity. 8 Tendons are dense collagenous tissues that transmit tensile forces between muscle and skeleton. They consist primarily of collagen fibres of differing quality oriented in the direction of the load.…”