Generalized Hertz model for bimodal nanomechanical mapping

Abstract

SummaryBimodal atomic force microscopy uses a cantilever that is simultaneously driven at two of its eigenmodes (resonant modes). Parameters associated with both resonances can be measured and used to extract quantitative nanomechanical information about the sample surface. Driving the first eigenmode at a large amplitude and a higher eigenmode at a small amplitude simultaneously provides four independent observables that are sensitive to the tip–sample nanomechanical interaction parameters. To demonstrate this, a generalized theoretical framework for extracting nanomechanical sample properties from bimodal experiments is presented based on Hertzian contact mechanics. Three modes of operation for measuring cantilever parameters are considered: amplitude, phase, and frequency modulation. The experimental equivalence of all three modes is demonstrated on measurements of the second eigenmode parameters. The contact mechanics theory is then extended to power-law tip shape geometries, which is applied to analyze the experimental data and extract a shape and size of the tip interacting with a polystyrene surface.

Ferroelectric or non-ferroelectric: Why so many materials exhibit “ferroelectricity” on the nanoscale

“…However, there are methods are being developed that may overcome this challenge. 363 Moreover, not all ferroelectric systems will exhibit the field-induced phase transitions that allow for direct observation of the softening, although an alternative route is the ferroelectric phase transition itself (presuming it is at an accessible temperature for the AFM).…”

Metallo‐supramolecular Crosslinked Polyurethanes

“…Atomic force microscopy (AFM)‐stiffness imaging was used to produce modulus maps of the PU surface for all samples. Modulus imaging was performed using a Cypher AFM with an ARC2 controller (Asylum Research) using the AMFM multifrequency modulus/stiffness mapping technique . Commercial silicon AFM tips (AC200TS, Asylum Research), having a 10 nm nominal radius and a nominal first bending mode spring constant of 9.7 N/m, were used as received.…”

Background data for modulus mapping high-performance polyethylene fiber morphologies

“…Background as to how the mode works as is appied using a contact mechanics model are found in the literature [2]. While this AFM technique has similarities to other AFM modulus mapping techniques such as fast force curves, although these other techniques include different cantilever and contact dynamics as well as typically a different contact mechanics model.…”