From Micro to Nano Thin Polymer Layers: Thickness and Concentration Dependence of Sorption and the Solvent Diffusion Coefficient

Abstract

From sorption experiments in literature it is known, that the solvent diffusion coefficient in nanoscale polymer layers decreases compared to its value in thicker films due to an increasing influence of the substrate. However, it is unclear whether this behavior is only related to thickness variation or also to concentration dependency, inadequate measurement routines, nonconsidered influence of phase-equilibrium or unsuitable data analysis. Here, we describe a measurement setup on the basis of a quartz crystal microbalance, that allows for a clear differentiation between the parameters thickness and concentration. For the material system poly(vinyl acetate)-methanol, sorption experiments with dry film thicknesses ranging from 50 to 685 nm on SiO 2 and gold surfaces were conducted and analyzed using different evaluation methods. A comparison to micrometerscale data (30 μm) reveals that the phase equilibrium does not vary with film thickness, but the diffusion coefficient decreases by orders of magnitude due to both thickness (10 −13 to 10 −16 m 2 /s) and concentration (10 −11 to 10 −13 m 2 /s). On the basis of the different evaluation methods we propose a model that divides the diffusional characteristics in two zones: a top layer with bulk-like behavior and a substrate-near region where solvent diffusion is significantly slower.

Moisture Adsorption Behavior in Anodes for Li‐Ion Batteries

“…Pressure measurements of the gas phase for detecting the adjusted activity succeed by a pressure sensor from MKS Instruments. This setup is also restricted to higher activities at 30 °C cell temperature starting from approximately 20% …”

“…This is only one among several measurement techniques to obtain sorption isotherms. A well‐established measurement technique for sorption measurements in thin polymer layers consists of measurements, in which the increase in mass is detected by the change of resonance frequency in a quartz crystal on which the investigated layer is coated . Kachel et al made use of the possibility to measure many samples at the same time in a climatic chamber .…”

Swelling of 9 polymers commonly employed for solvent-resistant nanofiltration membranes: A comprehensive dataset

“…(25)). Secondly, thin films may behave systematically different from bulk samples, for instance because of nano-confinement effects (e.g., interface effects, polymer chain relaxation dynamics, residual stress) [21] or different time scales for diffusion as a result of the different diffusion length [22,23].…”

Predicting 3D moisture sorption behavior of materials from 1D investigations

“…Such discrepancies lead to large errors in the prediction of long term behavior (for example, shelf life estimation of food and medicinal products) 32 . Furthermore, bulk material properties in dynamic environments will deviate from the laboratory-based characterization of thin or small samples 33 – 35 . Without a unified dynamic multi-mode modeling approach, an accurate estimation of inherently dynamic materials–moisture interactions will be hindered..…”