From an atomic layer to the bulk: Low-temperature atomistic structure and ferroelectric and electronic properties of SnTe films

Abstract

SnTe hosts ferroelectricity that competes with its weak non-trivial band topology: in the highsymmetry rocksalt structure -in which its intrinsic electric dipole is quenched-this material develops metallic surface bands, but in its rhombic ground-state configuration -that hosts a non-zero spontaneous electric dipole-the crystalline symmetry is lowered and the presence of surface electronic bands is not guaranteed. Here, the type of ferroelectric coupling and the atomistic and electronic structure of SnTe films ranging from 2 to 40 ALs are examined on freestanding samples, to which atomic layers were gradually added. 4 AL SnTe films are antiferroelectrically-coupled, while thicker freestanding SnTe films are ferroelectrically-coupled. The electronic band gap reduces its magnitude in going from 2 ALs to 40 ALs but it does not close due to the rhombic nature of the structure. These results bridge the structure of SnTe films from the monolayer to the bulk. arXiv:1904.01702v1 [cond-mat.mes-hall]

Thermal conductivity and enhanced thermoelectric performance of SnTe bilayer

“…The conduction band minima (CBM) is found along Y -Γ path and valence band maxima (VBM) is along Γ -X path as shown in Figure 2. The electronic band gap here is in agreement with the previous theoretical result of ~ 0.63 eV, 34 and smaller than the experimental value ~ 0.9 eV. 17 The difference in between the calculated and experimental result is due to the typical problem of Kohn Sham theory in underestimating the band gaps up to 50%.…”

Two-dimensional monoelemental germanene nanosheets: facile preparation and optoelectronic applications

“…Previous theoretical investigations have evidence that keep the 2D materials away from water and oxygen can enhance the stability of free-standing 2D material significantly. 38,39 Before the sonication, keeping blow the inert gases argon into the Ge NMP solution for a period to remove the oxygen in the solution. After that, the bottle was sealed to cut off oxygen supply during the synthesis of 2D material.…”

Quasi‐1D Antiferroelectricity in Centrosymmetric CsTaS3 Crystal

“…Low-dimensional systems have attracted tremendous attention for their huge potential application in photovoltaics, [1] electronics, [2] and sensors. [3] Especially, driven by the increasing demands of electronics miniaturization, numerous new ferroelectric (FE) nanomaterials have been reported theoretically and experimentally for promising device applications, such as nonvolatile random-access memory devices, [4] fieldeffect transistors (FET), [5] and sensors.…”