Fouling analysis of membrane bioreactor treating antibiotic production wastewater at different hydraulic retention times

Abstract

Membrane fouling, including foulants and factors, was investigated during hydraulic retention time (HRT) optimization of a membrane bioreactor (MBR) that treated wastewater from the production of antibiotics. The results showed that HRT played an important role in membrane fouling. Trans-membrane pressure (TMP), membrane flux, and resistance were stable at -6 kPa, 76 L m h bar, and 4.5 × 10 m when HRT was at 60, 48, and 36 h, respectively. Using Fourier transform infrared spectroscopy, foulants were identified as carbohydrates and proteins, which correlated with effluent organic matter and effluent chemical oxygen demand (COD) compounds. Therefore, membrane fouling trends would benefit from low supernatant COD (378 mg L) and a low membrane removal rate (26 %) at a HRT of 36 h. Serious membrane fouling at 72 and 24 h was related to soluble microbial products and extracellular polymeric substances in mixed liquor, respectively. Based on the TMP decrease and flux recovery after physical and chemical cleaning, irremovable fouling aggravation was related to extracellular polymeric substances' increase and soluble microbial products' decrease. According to changes in the specific oxygen uptake rate (SOUR) and mixed liquor suspended solids (MLSSs) during HRT optimization in this study, antibiotic production wastewater largely inhibited MLSS growth, which only increased from 4.5 to 5.0 g L when HRT was decreased from 72 to 24 h, but did not limit sludge activity. The results of a principal component analysis highlighted both proteins and carbohydrates in extracellular polymeric substances as the primary foulants. Membrane fouling associated with the first principal component was positively related to extracellular polymeric substances and negatively related to soluble microbial products. Principal component 2 was primarily related to proteins in the influent. Additional membrane fouling factors included biomass characteristics, operational conditions, and feed characteristics.

Biological treatment of real petrochemical wastewater containing styrene using submerged membrane bioreactor: effects of HRT

“…By decreasing HRT to 6 h, after 7 days, TMP began to rise, and this trend continued until the MBR was turned off. Increasing membrane fouling rate with decreasing HRT has been observed in previous studies (Deng et al 2016;Isma et al 2014;Yu et al 2015).…”

Evaluasi Kinerja Sistem Bioreaktor Membran pada Instalasi Pengolahan Lindi (Studi Kasus: TPA Supit Urang, Kota Malang)

“…Nilai HRT tersebut sangat tinggi untuk bioreaktor membran. Bioreaktor membran membutuhkan HRT yaitu 12 jam agar menghindari terjadinya fouling [18]. HRT yang tinggi pada bioreaktor membran dapat menyebabkan fouling karena semakin lama waktu tinggal cairan di dalam membran, semakin banyak pula partikel padatan yang tertahan dan menumpuk pada permukaan membran.…”

Integration of anammox into the MBR process for main stream sewage treatment

“…As a result, membrane contamination is sure to occur when membrane modules are used for long periods of time. (Yu et al 2017).…”