Flux growth of (Pb,La)(Zr, Sn,Ti)O3 single crystals and their characterization

Xue, Lihong; Liu, Qiang; Zhang, Shujun; Zhen, Xihe; Li, Rui; Wang, Lin

doi:10.1016/j.jcrysgro.2005.05.066

Cited by 15 publications

(6 citation statements)

References 19 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…2a shows the grow step pattern observed on the surface. This growth pattern indicates that the mechanism of crystal growth is a two-dimensional nucleation layer growth, which is consistent with what was proposed by Xue et al [14]. Fig.…”

Section: Growth Results and Morphology Analysessupporting

confidence: 92%

Growth and characterization of (Pb, La)(Zr, Sn, Ti)O3 single crystals

Liu

Wang

et al. 2011

Journal of Crystal Growth

Self Cite

View full text Add to dashboard Cite

Section: Growth Results and Morphology Analysessupporting

confidence: 92%

Growth and characterization of (Pb, La)(Zr, Sn, Ti)O3 single crystals

Liu

Wang

et al. 2011

Journal of Crystal Growth

Self Cite

View full text Add to dashboard Cite

“…Many chemical preparation routes such as, ultrasonic spray combustion synthesis (USCS) [14], co-precipitation [15,16], flux growth [17], hydrothermal [18], sonochemical [19], diffusion process [20] gel-combustion [21] and sol-gel methods [22][23][24][25] have been employed to prepare single-phase nanocrystalline PZT powders.…”

Section: Introductionmentioning

confidence: 99%

Effect of sol–gel pH on XRD peak broadening, lattice strain, ferroelectric domain orientation, and optical bandgap of nanocrystalline Pb1.1(Zr0.52Ti0.48)O3

Pakizeh

Moradi

Ahmadi

2014

Journal of Physics and Chemistry of Solids

View full text Add to dashboard Cite

“…In a similar PLZT material, Sn 4+ substitution leads to the narrowing of the hysteresis loop and shifts T m toward lower temperatures. The properties of PLZST single crystals are described in and for PLZST ceramics.…”

Section: Introductionmentioning

confidence: 99%

Technology and Properties of PBZTS Ceramics

Skulski

Bochenek

Wawrzała

et al. 2012

Int J Applied Ceramic Tech

View full text Add to dashboard Cite

This paper presents the results of preparing and investigating the solid solution of lead barium zirconate titanate stannate (Pb1−xBax)[(Zr1−yTiy)1−zSnz]O3 with x = 0.25, y = 0.35 and z = 0.00, 0.02, 0.04, 0.08, 0.10. Ceramic samples were obtained from oxides and carbonates using conventional ceramic technology and pressureless sintering. The results of Energy‐dispersive X‐ray spectroscopy (EDS) investigations, XRD studies, as well as dielectric measurements and electromechanical investigations are presented. It was stated that at the room temperature, the structure of the investigated samples is pseudo‐cubic, typical for relaxors. Maximal value of elementary cell parameter is observed for z = 0.02, and for higher values of z, we observe almost linear decrease with increasing z. It was found that with increasing content of the Sn, the temperature Tm at which dielectric permittivity reaches its maximum decreases. Analyzing P‐E hysteresis loops it was stated that the phase transition in the investigated samples takes place at temperatures approximately 100°C lower than the temperature of the dielectric permittivity maximum. The temperature of phase transition was calculated also from hysteresis loops and compared with that obtained from measurements of dielectric permittivity.

show abstract

Flux growth of (Pb,La)(Zr, Sn,Ti)O3 single crystals and their characterization

Cited by 15 publications

References 19 publications

Growth and characterization of (Pb, La)(Zr, Sn, Ti)O3 single crystals

Growth and characterization of (Pb, La)(Zr, Sn, Ti)O3 single crystals

Effect of sol–gel pH on XRD peak broadening, lattice strain, ferroelectric domain orientation, and optical bandgap of nanocrystalline Pb1.1(Zr0.52Ti0.48)O3

Technology and Properties of PBZTS Ceramics

Contact Info

Product

Resources

About