Fluorescent Detection of Nitrobenzene Vapors via Fluorophore-Doped Polystyrene Materials

Abstract

Integration of fluorescent substances into polymeric matrices can improve their sensory properties and photostability. In this work, fluorescent materials based on fluorophore-doped polystyrene were obtained and characterized as sensors towards the ecotoxicant nitrobenzene in gas phase. Melamine-formaldehyde foam has been proposed as a permeable substrate for the sensor material deposition applicable for gas-phase measurements. The effect on sensor properties of the porous material surface obtained via Breath Figure pore generation technique was investigated. Limits of detection and calibration relationships of obtained materials towards nitrobenzene were evaluated by materials exposure to low concentrations of nitrobenzene vapors. The sorption properties of polystyrene allow the retention of the quencher near the fluorophore, leading to improved detection limits compared with pure fluorophores. Obtaining a porous surface of the polymer material by the Breath Figure technique increases the scale of its fluorescence quenching by vapors. Detection limits (down to 0.45 ppm) and detectable concentration ranges (0.5 - 371.6 ppm) have been experimentally established. The relative standard deviations of the fluorescent signal of polymer materials do not exceed 13.3 % for a number of concentrations in the detectable range. The applicability of the calibration linear relationship of the logarithm of the fluorescent signal on the logarithm of the nitrobenzene vapor concentration is shown. Fluorescence signal measurements were performed using the original sensor element and the luminescence detector employing an array of fluorescent materials. The developed device is simple in application, portable, automated, and in combination with the used polymeric materials allows detection of nitrobenzene vapors in concentrations 2.5 times lower than the maximum permissible level.