Flow metering characterization within an electrical cell counting microfluidic device

Abstract

Microfluidic devices based on the Coulter principle require a small aperture for cell counting. For applications using such cell counting devices, the volume of the sample also needs to be metered to determine the absolute cell count in a specific volume. Hence, integrated methods to characterize and meter the volume of a fluid are required in these microfluidic devices. Here, we present fluid flow characterization and electrically-based sample metering results of blood through a measurement channel with a cross-section of 15 μm × 15 μm (i.e. the Coulter aperture). Red blood cells in whole blood are lysed and the remaining fluid, consisting of leukocytes, erythrocyte cell lysate and various reagents, is flown at different flow rates through the measurement aperture. The change in impedance across the electrodes embedded in the counting channel shows a linear relationship with the increase in the fluid flow rate. We also show that the fluid volume can be determined by measuring the decrease in pulse width, and increase in number of cells as they pass through the counting channel per unit time.

A microfluidic biochip for complete blood cell counts at the point-of-care

“…However, the translation of their optical device to a portable system will have illumination non-uniformity and higher noise issues that they also mentioned in their article 17 . In our previous studies, we have also characterized in detail our microfluidic impedance sensors to count CD4 and CD8 T cells for HIV diagnostics using a differential capture technique 18,19 . We have also characterized the coincidence effects in our counter 20 and performed a detailed mathematical characterization of the electrical cell counting process 21 .…”

Lab-on-Chip Cytometry Based on Magnetoresistive Sensors for Bacteria Detection in Milk

“…Over the past years, the drawbacks of conventional flow cytometers have encouraged efforts to take advantage of microfabrication technologies and advanced microfluidics to achieve smaller, simpler, more innovative and low-cost instrumentation with enhanced portability for on-site measurements. This miniaturization approach has in general made use of inexpensive polymers such as polydimethylsiloxane (PDMS) [18] and detection techniques easily integrated with electronics [19], such as optical fibers [20], CCD cameras [21], diode lasers [22,23], PIN photodiodes [24], electrodes [25] and magnetoresistive sensors [26]. Approaches such as label-free electrical impedance-based ones [27,28], while quantitative and high throughput, present high sensitivity to the sample matrix, being affected by components in the sample other than the target, specifically their charges, which greatly hinders these devices' use in off-laboratory locations.…”

A point-of-care microfluidic biochip for quantification of CD64 expression from whole blood for sepsis stratification

“…Our group has previously developed a microfluidic biochip capable of performing blood cell counts from a drop of whole blood without any manual processing26. The electrical sensors are designed to count individual cells using the coulter principle, where the passage of a cell perturbs the electrical current within an orifice, creating a distinct impedance pulse262728. The biochip has shown good correlations in clinical studies when its cell counts were compared to the cell counts from haematology analyzers.…”