First Successful 12.25-in. Openhole Whipstock Sidetrack Operation in a Complex Middle East Formation: A Kuwait Case Study

Abstract

Sidetracking a preexisting drilled and cased wellbore poses numerous challenges. When sidetracking in an openhole environment, additional verifications of hole conditions are needed, which contribute additional unique challenges. In this type of wellbore, the operators must plan by selecting the sidetracking depth and then ensure that all the objectives are met from a well authorization for expenditure standpoint and geological target perspective. The quality of the openhole window or rathole is of immense concern to operators because this quality ensures that the bottomhole assemblies (BHAs) will pass through the rathole without difficulty. The openhole gauge must be confirmed because it can pose additional risks that might lead to costly multiple trips into the well to ensure that the rathole is in good condition. This paper presents a unique case study in which the operator, Kuwait Oil Company (KOC), was faced with the possibility of geological losses at the kickoff in the wellbore while attempting to sidetrack an existing wellbore. The operator contacted an oilfield services company and requested a unique technical solution to precisely sidetrack the wellbore in the difficult formation containing fractured dolomites, which are known to cause severe to complete losses. While drilling the 12.25-in. section, the BHA became stuck in the fractured dolomitic limestone formation. In this section, the operator had previously experienced severe to complete losses. Because fishing attempts to free the stuck BHA were not successful, the operator decided to sidetrack the wellbore in the open hole using an openhole whipstock. A casedhole sidetrack option was ruled out because reactive swelling shales with producing sands were located above the sidetrack depth; therefore, combining these zones was not practical because of the low-mud-weight limit required for drilling the fractured dolomite below the target depth. In addition, because only 70 ft of open hole existed between the 13.375-in. casing shoe and the stuck BHA in the hole, sidetracking with a cement plug was nearly impossible. The openhole wellbore was logged with a caliper to confirm the wellbore gauge. Prejob planning consisted of understanding the compressive rock strength from the offset wells to identify the lithological challenges unique to this application. A hazard analysis risk-control method was adopted to identify the risks and apply appropriate mitigation measures. An operating parameters plan was formulated by the engineering team and discussed with the operator and service company personnel and followed throughout the job. The wellbore was successfully sidetracked in the 12.25-in. section in a single run using an openhole whipstock, avoiding the loss zone, and resulting in additional cost savings to the operator. The condition of the sidetracked rathole enabled smooth passage of the directional BHA to meet the directional objectives. Furthermore, the openhole whipstock operation eliminated the need for multiple cement plugs in the sidetrack (in view of severe loss zones below) as well as the time required for drilling with a dedicated motor BHA for openhole sidetracking operation, saving the operator a minimum of 6 days of rig time. This operation was the first successful 12.25-in. openhole sidetrack operation in the Middle East, Asia-Pacific, and sub-Sahara Africa regions. As a result of this successful operation, the operator is proactively recommending the new solution across the entire KOC organization for wells with similar scenarios. By applying this unique and reliable openhole whipstock technical solution, the drilling team was able to deliver a successful well based on the original casing plan without any need for further sidetracks or changes to the wellbore casing design.