Finding efficient frontier of process parameters for plastic injection molding

Abstract

Product quality for plastic injection molding process is highly related with the settings for its process parameters. Additionally, the product quality is not simply based on a single quality index, but multiple interrelated quality indices. To find the settings for the process parameters such that the multiple quality indices can be simultaneously optimized is becoming a research issue and is now known as finding the efficient frontier of the process parameters. This study considers three quality indices in the plastic injection molding: war page, shrinkage, and volumetric shrinkage at ejection. A digital camera thin cover is taken as an investigation example to show the method of finding the efficient frontier. Solidworks and Moldflow are utilized to create the part's geometry and to simulate the injection molding process, respectively. Nine process parameters are considered in this research: injection time, injection pressure, packing time, packing pressure, cooling time, cooling temperature, mold open time, melt temperature, and mold temperature. Taguchi's orthogonal array L27 is applied to run the experiments, and analysis of variance is then used to find the significant process factors with the significant level 0.05. In the example case, four process factors are found significant. The four significant factors are further used to generate 3 4 experiments by complete experimental design. Each of the experiments is run in Moldflow. The collected experimental data with three quality indices and four process factors are further used to generate three multiple regression equations for the three quality indices, respectively. Then, the three multiple regression equations are applied to generate 1,225 theoretical datasets. Finally, data envelopment analysis is adopted to find the efficient frontier of the 1,225 theoretical datasets. The found datasets on the efficient frontier are with the optimal quality. The process parameters of the efficient frontier are further validated by Moldflow. This study demonstrates that the developed procedure has proved a useful optimization procedure that can be applied in practice to the injection molding process.

Process capability improvement of an engine connecting rod machining process

“…Sharma et al (2013a), b in their papers adopted the DMAIC approach to solve the bolt hole center distance and crankpin bore honing operations of the connecting rod manufacturing process. Chen et al (2013) discussed the application of ANOVA methodology to find significant parameters that affect the part's quality indices with respect to plastic injection molding.…”

Quality Assurance through Process Improvement - A Concise Review

“…In the field of quality assurance, DEA is employed for simultaneous optimization of multiple interrelated quality indices, leading to product quality improvement [14]. Multiple regression equations are set up and used to produce the dataset for DEA analysis.…”

“…The surface finish of the shaft was identified as a critical to quality characteristic and ANOVA finds place as a part in the manufacturing process improvement. During the manufacture of front cover of a digital camera [14], the ANOVA methodology was applied to find the significant process parameters that affect the part's quality indices. The results showed that four out of nine process parameters were significant with a significance level of 0.05.…”

Process capability improvement through DMAIC for aluminum alloy wheel machining

“…The modern work on process control was pioneered by Schilling (1994) and was succeeded by employing process control charts by John (1994). Process capability indices, process failure modes and effects analysis (PFMEA), Taguchi's orthogonal array, control charts and process capability monitoring figure comprise the various tools for achieving the sustained process improvements (Lin 2004;Rupinder Singh 2011;Lin et al 2013;Kumaravadivel and Natarajan 2013;Mariajayaprakash et al 2013;Chen et al 2013;Lal et al 2013;Burlikowska 2005;Yu et al 2007).…”