Fiber Laser Welded Cobalt Super Alloy L605: Optimization of Weldability Characteristics

Abstract

The present study describes the laser welding of Co-based superalloy L605 (52Co-20Cr-10Ni-15W) equivalent to Haynes-25 or Stellite-25. The influence of laser welding process input parameters such as laser beam power and welding speed on mechanical and metallurgical properties of weld joints were investigated. Epitaxial grain growth and dendritic structures were visible in the weld zone. The phase analysis results indicate the formation of hard phases like CrFeNi, CoC, FeNi, and CFe in the weld zone. These hard phases are responsible for the increase in microhardness up to 321 HV0.1 in the weld zone, which is very close to the microhardness of the parent material. From the tensile strength tests, the ductile failure of welded specimens was confirmed due to the presence of dimples, inter-granular cleavage, and micro voids in the fracture zone. The maximum tensile residual stress along the weld line is 450 MPa, whereas the maximum compressive residual stress across the weld line is 500 MPa. On successful application of Response Surface methodology (RSM), laser power of 1448.5 W and welding speed of 600 mm/min i.e., line energy or heat input equal to 144 J/mm, were found to be optimum values for getting sound weld joint properties. The EBSD analysis reveals the elongated grain growth in the weld pool and very narrow grain growth in the heat-affected zone.

Numerical simulation and experimental study of residual stress in dissimilar aluminum alloy laser composite welding

“…One of the reasons for the sharp change in stress is the cooling rate. 35,36 Conclusion 1. In terms of longitudinal residual stress, in the direction parallel to the X-axis, the sides of 6063 aluminum alloy and 5083 aluminum alloy are mainly tensile stress, and the areas near the start and end of the workpiece are mainly compressive stress.…”