Features of diffusion processes in the preparation of prepregs by the method of layered application of components

Abstract

The modern production of products made of composite materials based on thermosetting binders is mainly based on the use of pre – impregnated reinforcing technical threads-prepregs. The binder used for such semi-finished products must meet two important technological requirements: have a low reactivity (high viability) when stored in the temperature range from -5 to +25 ° C and the ability to adjust the curing time at the molding temperatures of the product. To eliminate the disadvantages of the traditional method of obtaining polymer composite materials, to improve their strength characteristics and reduce the cost of the resulting reinforced composites, it is proposed to use the method of layered application of components. The essence of the method consists in layer-by-layer impregnation of the fibrous filler with a binder solution, and then a developed curing system consisting of an amine hardener that prevents the interaction of the hardener with the resin under storage conditions and protective polymer emulsions. The binder-filler system is activated only at an elevated temperature under curing conditions. It is established that the optimal parameters for processing by direct pressing of the pre-pegs components obtained by the method of layer deposition are a pressure of 15 MPa and a temperature of160-170 ?С with a pressure exposure of 15 minutes. If you get products by winding, then for such products, heat treatment for 6 hours at a temperature of 120 ?С is optimal. In the conditions of forming products, that is, at an elevated temperature and at an increased pressure, the mutual diffusion of components occurs due to the movement of oncoming flows. Oligomeric molecules from the resin volume diffuse from the inner layer to the outer one, and the components of the curing system meet them from the outer layer to the inner one. The method of layered application of components makes it possible to create a macroheterogenic system of interpenetrating polymer meshes in the contact area of sequentially applied layers. The result of the research is an increase in the shelf life, the viability of prepregs (up to 10 days) and an improvement in the complex of physical and mechanical properties of composites: the destructive stress during static bending increases to 60 %, during dynamic bending (impact) - up to 50 %. The use of carboxymethylcellulose as a protective polymer provides higher indicators of the studied properties than when using butadiene styrene latex as a protective polymer..

Study of Prepregs Lifetime Based on Epoxy Resin With Aromatic Amine Hardener

“…The authors of [30] report that epoxy prepreg samples containing a cycloaliphatic amine can be stored at room temperature for at least 50 days. In work [31], epoxy prepregs were obtained with the presence of protective polymers in the curing system, which prevented the interaction of the hardener with the resin under storage conditions, allowing the viability of prepregs to be increased to 10 days.…”