Feasibility of <i>Cordia trichotoma</i> (Vell.) wood and its by-products for particleboard manufacturing

Trianoski, Rosilani; Iwakiri, Setsuo; Machado, Lucas; Rosa, Thiago Souza da

doi:10.1080/10549811.2017.1381028

Cited by 4 publications

(2 citation statements)

References 11 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…WBBs such as medium density fiberboard (MDF), plywood (HWPW) and particleboard (PB) are widely used in interior reinforcement elements and thin construction elements. Their usage time is also quite long (Shalbafan et al, 2016;Trianoski et al, 2017;Latorraca et al, 2009;Salthammer et al, 2010 andTang et al, 2009). As a result, the manufacture method and stages of WBBs have become a very important issue in terms of being compatible with the environment wood based materials and products.…”

Section: Introductionmentioning

confidence: 99%

Formaldehyde Emission in Different Positions of Wood-Based Boards Used in Interior Architecture

Yıldırım

Çınar

Erdem

2022

DepArch

View full text Add to dashboard Cite

This research focuses on determining the effects on the formaldehyde emission (FE) of the middle and edge parts of two different wood-based boards (WBBs) consisting of medium density fiberboard (MDF) and particleboard (PB), which are widely used in interior architecture. Samples with the thicknesses of 18 mm were analyzed for FE at a temperature of 20 °C and 65% relative moisture content for 1, 2 and 3 hours after manufacture. In the PB samples, the highest value of FE (0.4119 ppm) was determined in the samples obtained from the center while the lowest emission value (0.0875) was observed in the samples obtained from the edge. In the MDF samples, the highest value of FE (0.3012 ppm) was determined in the samples from the center while the lowest emission value (0.1807 ppm) was observed in the samples from the edge. The PBs have a higher environmental impact (0.2497 ppm) than the MDFs (0.2454 ppm). For distances to minimum values (0.10 ppm), while the furthest value for the central samples of PB was 311%, the closest value for the edge samples of PB was -12.5%.

show abstract

Section: Introductionmentioning

confidence: 99%

Formaldehyde Emission in Different Positions of Wood-Based Boards Used in Interior Architecture

Yıldırım

Çınar

Erdem

2022

DepArch

View full text Add to dashboard Cite

show abstract

“…The high demand and competitiveness for these wood species in order to make other types of panels, such as fiberboard and plywood, in addition to sawn wood, create the need to increase planting areas or seek alternative species of fast growth (Trianoski et al, 2017). According to Trianoski et al (2011) and Bianche et al (2012), the use of new species, pure or mixed with traditional species, in the production of particleboard is characterized as a fast, low cost, and sustainable alternative.…”

Section: Introduction and Objectivesmentioning

confidence: 99%

Use of Populus deltoides wood in the Production of MDP and HDP

2021

View full text Add to dashboard Cite

The aimed to evaluate the properties of MDP and HDP panels, produced with pure Populus deltoides or in a mixture with Pinus taeda, together with urea-formaldehyde resin. The density and chemical properties of this wood with 8 and 12 years of age were determined, which were used for the production of panels with nominal density of 0.65 and 0.90 g.cm -3 . Water absorption and thickness swelling tests were performed after 2 and 24 hours of immersion, as well as static bending and perpendicular tensile. Populus deltoides wood was classified as low-density in both ages and presented chemical properties similar to Pinus taeda. Mechanical properties obtained for the panels produced reached the minimum requirements values established by the standards NBR 14810-2 and ANSI A208.1, demonstrating the potential use of wood species for the production of MDP and HDP panels, at both ages studied and used pure or mixed with Pinus taeda wood.

show abstract

Application of Cordia trichotoma sawdust as an effective biosorbent for removal of crystal violet from aqueous solution in batch system and fixed-bed column

Grassi

Drumm

Georgin

et al. 2020

Environ Sci Pollut Res

View full text Add to dashboard Cite

Feasibility of Cordia trichotoma (Vell.) wood and its by-products for particleboard manufacturing

Cited by 4 publications

References 11 publications

Formaldehyde Emission in Different Positions of Wood-Based Boards Used in Interior Architecture

Formaldehyde Emission in Different Positions of Wood-Based Boards Used in Interior Architecture

Use of Populus deltoides wood in the Production of MDP and HDP

Application of Cordia trichotoma sawdust as an effective biosorbent for removal of crystal violet from aqueous solution in batch system and fixed-bed column

Contact Info

Product

Resources

About