Feasibility analysis and cutting process research on laser cutting medium-thick 20CrNiMo steel plates using a high-power fiber laser without assisted blowing

Liao, Wenling; Wang, Guorong; Zhong, Lin; Chen, Yinan; Wang, Jie

doi:10.1016/j.jmapro.2024.01.020

Cited by 2 publications

(1 citation statement)

References 24 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…These challenges underscore the importance of laser cutting processes, which involve intricate interactions among material properties, laser beam characteristics, and cutting auxiliary gases [30][31][32] . Parameters such as material type, thickness, surface condition, laser mode, power, cutting speed, assist gas type, pressure, focal position, and nozzle dimensions signi cantly impact cutting quality [33][34][35] .…”

Section: Introductionmentioning

confidence: 99%

Experimental Study on Laser Cutting Process of Simulated Fast Reactor Fuel Rods

Li,

Mo,

Chen

et al. 2024

Preprint

View full text Add to dashboard Cite

The cladding of fast reactor fuel rod is fabricated using stainless steel, which, owing to its ductility, presents challenges such as increased tool wear and diminished cut quality when mechanically sheared. In light of technological advancements, laser cutting has emerged as a superior method due to its flexibility and high efficiency. The quality of laser-cut fuel rod significantly influences subsequent processing of short segments. This study systematically analyzes the impact of various laser cutting parameters on the cutting quality of simulated fast reactor fuel rod. Optimization of cutting speed, focal position, power, and gas pressure has substantially improved cutting effectiveness. Experimental findings indicate that a combination of 1 m/min cutting speed, focal position ranging from − 20 mm to -25 mm, power between 7200 W and 9600 W, and 10 MPa gas pressure achieves the optimal balance between efficiency and quality, providing crucial insights for the efficient cutting of fast reactor fuel rod.

show abstract