Failure and Deformation Mechanisms of Vertical Plate Anchors Subjected to Lateral Loading in Sand

Yue, Hongya; Zhuang, Pei‐Zhi; Song, Xiuguang

doi:10.1061/(asce)gm.1943-5622.0001859

Cited by 13 publications

(1 citation statement)

References 56 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…Because of its excellent bearing capacity and deformation resistance, the vertical plate anchor is often used in permanent anchoring engineering, such as retaining walls, sheet piles, etc. [1,2]. Because the bearing capacity design has been a focus [3], the bearing behavior of vertical plate anchors becomes critical for its theoretical basis signi cance.…”

Section: Introductionmentioning

confidence: 99%

Microscopic Bearing Behavior of Horizontally Loaded Vertical Plate Anchors in Sandy Soil

Zhang

Wang

et al. 2022

Advances in Civil Engineering

View full text Add to dashboard Cite

Vertical plate anchors are an effective technique to enhance the stability of various structures, such as retaining walls and sheet piles. More research has been devoted to their bearing capacity and macroscopically affecting parameters, while less research can be found on their microscopic bearing behavior. In this paper, the microscopic bearing behavior of vertical plate anchors subjected to a horizontal pullout load in sandy soil was investigated with the particle flow code (PFC) based on the model test results. Results show that the larger-sized anchor plates withstand greater soil pressure and affect a broader range of soil during the pullout process. The soil not behind the anchor plate is pressed, and the pressure in front of the anchor plate increases with increasing size. The soil close to the plate anchor suffers larger pressure while the soil far away from the plate anchor is less affected, and the soil is redistributed to a more stable state during the pullout process of the plate anchor. The particles with a long axis distributed in the horizontal direction are the most stable, while those with a long axis distributed in the vertical direction are the most unstable.

show abstract

Section: Introductionmentioning

confidence: 99%