Factorial experimental design intended for the optimization of the alumina purification conditions

Mounaouer, Brahmi; Ba, M.; Hidri, Yassine; Hassen, Abdennaceur

doi:10.1016/j.molstruc.2017.12.071

Cited by 2 publications

(1 citation statement)

References 28 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…The process variables such as time and temperature during the EPDM-injection molding not only change the physical properties of the raw material but also affect the insertion and separations forces when a grommet product is molded and mounted on a car body. Using the design of experiments method [7][8][9], the major factors in the injection molding process were considered to analyze their effects on the physical properties of the obtained EPDM materials. Test pieces were prepared under different process conditions, tensile strength and elongation were measured, and their correlation was analyzed.…”

Section: Introductionmentioning

confidence: 99%

Effects of Injection Molding Process Conditions on Physical Properties of EPDM Using Design of Experiment Method

Kim

Jeon

Hwang³

2018

MATEC Web Conf.

View full text Add to dashboard Cite

Abstract.The process variables such as time and temperature during the EPDM-injection molding not only change the physical properties of the raw material but also affect the insertion and separations forces when a grommet product is molded and mounted on a car body. Using the design of experiments method, the major factors in the injection molding process were considered to analyze their effects on the physical properties of the obtained EPDM materials. Test pieces were prepared under different process conditions, tensile strength and elongation were measured, and their correlation was analyzed.

show abstract

Section: Introductionmentioning

confidence: 99%