Fabrication of high strength PVA/SWCNT composite fibers by gel spinning

Abstract

High-strength composite fibers were prepared from polyvinyl alcohol (PVA) (Degree of polymerization: 1500) reinforced by single-walled carbon nanotubes (SWCNTs) containing few defects. The SWCNTs were dispersed in a 10 wt.% PVA/dimethylsulfoxide solution using a mechanical homogenizer that reduced the size of SWCNT aggregations to smaller bundles. The macroscopically homogeneous dispersion was extruded into cold methanol to form fibers by gel spinning followed by a hot-drawing. The tensile strength of the well-oriented composite fibers with 0.3 wt.% SWCNTs was 2.2 GPa which is extremely high value among PVA composite fibers ever reported using a commercial grade PVA. The strength of neat PVA fibers prepared by the same procedure was 1.7 GPa. Structural analysis showed that the PVA component in the composite fibers possessed almost the same structure as that of neat PVA fibers.Hence a small amount of SWCNTs straightforward enhanced by 0.5 GPa the tensile strength of PVA fibers. The results of mechanical properties and Raman spectra for the SWCNT composites suggest the relatively good interfacial adhesion of the nanotubes and PVA that improves the load transfer from the polymer matrix to the reinforcing phase.-3 -

Lignin-based carbon fibers: Carbon nanotube decoration and superior thermal stability

“…As shown in Fig. 6B, the intensities of D and G 416 peaks remain relatively constant for all the fibers and their I D / 417 I G ratios are all close to 0.85, indicating similar structural per-418 fection of graphitic carbons [98]. Peak shifts on both D and G 419 peaks can be observed for the fibers containing Fe or Pd nano-420 particles, which is presumably caused by electron doping or 421 mechanical strain effects of the nanoparticles [99].…”

Semi-metallic, strong and stretchable wet-spun conjugated polymer microfibers

“…13 In particular, wet-spinning is a relatively simple process to produce continuous polymer microfibers by submerging the spinneret in a coagulation bath that causes the fiber to solidify. 13,14 Among the popular conjugated polymers, polypyrrole (PPy), polyaniline (PANI) and poly(3,4-ethylenedioxythiophene)/poly(styrenesulfonate)(PEDOT/PSS) have been successfully spun into microfibers by the wet-spinning process. 8,9,11,15 PEDOT/PSS has been found to have the best spinnability and its preparation technique can be scaled up to an industrial process.…”

Biohybrid Carbon Nanotube/Agarose Fibers for Neural Tissue Engineering

“…So far a popular method to fabricate CNT/polymer hybrids is through the technique of wet spinning. [23, 24, 28–34] Wet spinning has been utilized in producing CNT/polymer composite fibers for the last 10 years. [21, 23, 30] Despite its inherent advantage, the ability to scale up the production of CNT fibers, specifically those intended for biomedical applications, incurrs some drawbacks.…”