Fabrication and Energy Harvesting Measurements of Vibrating MEMS Piezoelectric Benders

Abstract

In this paper, a study is presented in which piezoelectric microbenders were fabricated and tested to demonstrate energy generating performance. Trapezoidal and diagonal (with respect to the substrate crystal directions) unimorph PZT cantilever benders with interdigitated electrode patterns were utilized. The interdigitated design is beneficial for microenergy harvesting devices because it utilizes the d33 mode, which can generate higher voltage than the d31 mode design. It can also eliminate the bottom electrode by only using an interdigitated top electrode, which facilitates fabrication, as opposed to the d31 mode design that requires both top and bottom electrodes. The micro-electromechanical system (MEMS) benders fabricated in this study consist of layers of SiO2/SiNx/ZrO2/PZT and Au/Cr interdigitated electrode on the top. The experimental results indicate that the fundamental frequencies of the microbenders are about 9.1 kHz for the trapezoidal bender and 18.48 kHz for the diagonal bender. The microtrapezoidal bender can generate power of approximately 1.4 μW into a 680 kΩ resistive load at the resonant frequency. The diagonal bender can generate power of about 18.2 μW into a 100 kΩ resistive load at the resonant frequency.

A stack-based flex-compressive piezoelectric energy harvesting cell for large quasi-static loads

“…Through advances in wireless sensor networks and microelectro-mechanical systems over the past couple of decades, energy harvesting from the ambient environment has become a hot research topic as a self-sustaining energy source [1][2][3]. Piezoelectric materials are ideal sources for energy harvesting since they can convert minor mechanical energy, which is often neglected or wasted, into electrical energy directly [4,5].…”